Votos - 3, Puntuación media: 4 ( )

Fabricar: GE Tamaño del archivo: 381.67 kb Nombre del archivo: Idioma del manual:

Cycle Signal Option (on some models) This signal will sound just before the end of the cycle to remind you to remove the clothes. On some models the signal sound level cannot be adjusted. If you selected the WRINKLE CARE option, the signal will sound at the end of the drying time and will sound several times during the WRINKLE CARE cycle. This will remind you that it is time to remove the clothes. NOTE: Remove garments promptly at the sound of the signal. Place clothes on hangers so wrinkles won’t set in. Use the Cycle Signal especially when drying fabrics like polyester knits and permanent press. These fabrics should be removed so wrinkles won’t set in. Automatic Cycle Signal (on some models) At the end of each cycle, there is A reminder signal will sound periodically approximately 15 minutes of no-heat during this time to remind you to remove tumbling after the laundry is dry. the laundry. 8 Drum Lamp (on some models) Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit breaker. Reach above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb. Drying Rack (on some models) A handy drying rack may be used for drying NOTE: delicate items such as washable sweaters. The drying rack must be used with the TIMED CYCLE. Hook the rack over the lint filter so the rack extends into the dryer drum. Do not use this drying rack when there are other clothes in the dryer. Stainless Steel Drum (on some models) The stainless steel used to make the normal use, the drum will not rust or dryer drum provides the highest reliability corrode. These surface blemishes will available in a GE dryer. If the dryer drum not affect the function or durability of should be scratched or dented during the drum. 9 Consumer SupportTroubleshooting Instructions About reversing the door. Safety InstructionsConsumer Support Troubleshooting Tips 1 Operating Instructions Reversing the Door ools needed: Standard #2 Tape-tipped Phillips screwdriver putty knife Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about half way into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in new holes. 2 3 Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT. Rotate the door 180°. Insert it on the opposite side of the opening by moving the door IN and DOWN until the top hinge and the bottom hinge are resting on the top screws inserted in step 1. 4 Remove the remaining screws from the side of the opening from which the door was removed. With these screws, secure each hi...

Descargar ahora

Introduzca dos números de la imagen: