The serial number is located on the right side mast as shown. REPLACEMENT PARTS Use only Genuine Honda Replacement parts to repair this machine. Honda replacement parts are available from your Honda Multi-purpose Tractor Dealer. To obtain prompt, efficient service, always remember to give the dealer the following information: -Correct part description or part number. -Model number of your machine. -Serial number of your machine. FRONT LOADER SAFETY FRONT LOADER SAFETY Operating the tractor and f

(FR750) l Turning the tiller during high-speed operation causes the tiller to turn abruptly and become unstable, resulting in injury or accident. l Do not turn the tiller when it is moving uphill or downhill. When the tiller is turned on a slope, it may abruptly move in an unforeseen direction, resulting in an accident, injury, or damage to the tiller. TILLING WORK Tilling deeply at first may cause the tiller to lurch forward suddenly. If a stone or hard object hits against the tines while tilli

’ l Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ig- nite. If any fuel is spilled, make sure the area is dry before starting the engine. l Avoid repeated oc prolonged contact with skin or breathing of vapor. KEEP OUT OF REACH OF CHILDREN. GASOLINES CONTAINING ALCOHOL If you decide to use a g’asoline containing alcohol (gasohol), be sure it’s octane rating is at least as high as that recommended by Honda. There are two types of “gasohol”: one containing ethanol, and

If only partially filled, air in the tank will promote fuel deterioration during storage. If you keepacontainer of gasoline for refueling, be sure that it containsonly fresh gasoline. Add fuel stabilizer following the manufacturer's instructions. After adding a fuel stabilizer, run the engine outdoors for 10minutes to be sure that treated gasoline has replaced the untreated gasoline in the carburetor. Stop the engine, and move the fuel valve lever to the OFF position. 54 STORAGE ~ Draining the F

is Hydrostatic transmission fluid Check the hydrostatic fluid level in the reservoir. Hydrostatic fluid expands and contracts with changes in temperature. The UPPER and LOWER level marks on the reservoir are calibrated for room temperature fluid. lt is normal for the fluid level to rise above the UPPER level mark when snowblower operation warms the transmission. When checking the level of cold fluid, below room temperature, refer to the temperature chart for appropriate fluid levels. At temperat

The oil level should be up to the lower edge of the check bolt hole. If the level is low, add oil until it begins to flow out of the hole (See page 8 for recommended oil). Fuel Remove the gas cap and check the fuel level. Refill the tank if the level is low. Fuel tank capacity: FR600: 3.6 Q (0.95 US gal, 0.79 Imp gal) FR800: 6.0 Q (1.59 US gal , 1.32 Imp gal) Gasoline is extremely flammable, and gasoline vapor can explode. Use extreme care when handling gasoline. Refuel in a well-ventilated area

92. OPERATION R Type (remote control) For panel mount or top mount remote control information, refer to the instructions provided with the remote control equipment. Side-Mount Type SWITCH CLIP LANYARD 1. Put the emergency stop switch clip in the emergency stop switch, and attach the lanyard to your PFD (Personal Flotation Device) or to your wrist, as shown. The engine will not start or run, unless the switch clip is in the emergency stop switch. The emergency stop switch clip and lanyard system

6. Reinstall the spark plugs, and put the emergency stop switch clip into the switch. 7. Attempt to start the engine. If the engine fails to start, remove the spark plugs, dry them, then reinstall the spark plugs and attempt to start the engine again. If the engine starts, and no mechanical damage is evident, continue to run the engine for a half hour or longer. Be sure the water level is at least two inches above the antiventilation plate to avoid overheating and water pump damage. 8. As soon a

-All Rights Reserved The engine exhaust from this product contains chemicals known to the State defects or other reproductive harm. Thank you for purchasing a Honda tiller. This manual describes operation and maintenance of your tiller: Honda FR600 and FR800. All information in this publication is based on the latest product information available at the time of printing. The illustrations in this manual are based on: Honda FR800 Honda Motor Co., Ltd. reserves the right to make changes at any tim

The information and specifications included in this publication were in effect at thetimeofapprovalforprinting.HondaMotor Co., Ltd. reserves the right, however, to discontinue or change specifications or design at any time without notice and without incurring any obligation whatever. No partofthispublicationmay be reproduced without written permission. INTRODUCTION A FEW WORDS ABOUT SAFETY Your safety and the safetyof others are very important. And using this water pump safely isan important res