Estos requisitos se basan en informes de prueba A.G.A. C-FT-5-90, C-FT-8-90, FT-C-1293 y FT-C-13-93. Ver Figura 4 y 5. 1. El aparato de calefaccion de gas (o aparatos multiples) de una entrada maxima de 250,000 BTU/hr. 2. Cada aparato del edificio DEBE tener su propio Figura 4 respiradero vertical separado y Starkap™. 3. La pared de conexion entre el edificio contiguo y la estructura principal DEBE estar sellada para evitar el flujo hacia la estructura principal. Ejemplo: Los garajes contiguos s

Make sure when installing the base the plated washer on the switch is raised approximately 3.16". The proving switch must be fully engaged. (See Figure 8) 14. With aluminum or foil tape, seal all joints and seams of the plenum near the mounting location to reduce any direct viewing of light. Figure 6 Figure 7 Figure 8 page 6 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire Air

With ClearWave™, the electric field generated is always being applied to the water, while a magnetic field relies on the movement of water to produce the electric potential changes. Low frequency waveforms are emitted through two coiled wires attached to the outside of the water pipe. As a result of these waveforms, the two coils are constantly inducing a voltage into the water in the area of the ClearWave™. When one coil induces a positive voltage the other coil induces a counteracting negative

Over a thirty day period, the moisture content was measured at weekly intervals. Homes with the Eliminator installed saw a reduction of moisture levels to as low as 16% and 17%. A wood moisture level of 20% or less is considered ideal. Homes without the Eliminator showed no reduction in moisture content. “The Eliminator performed well, even under severe moisture problem conditions… the amount of air moved is sufficient to correct the problems present.” Cliff Consulting Columbia, S.C. Moisture Co

. Approximately 30” OPTIONAL LOCATION 6” Figure 1 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. page 3 page 4 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV

Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. page 6 9. Swing the swivel bracket over the end of lamp. Hand-tighten the wing nut on the stud. Be careful not to over tighten the wing nut. The porcelain at the lamp base may crack when over tightened. (See Figure 17) 10. Plug ballast plug into end of lamp. (See Figure 18) 11. Snap cover onto the unit base. (See Figure 19) 12. Plug the LED wire from the cover onto the

Be careful not to over tighten the wing nut. 6. Attach ballast plug onto the end of the lamp. 7. Plug in the power cord and press the power switch to the ON position. 8. Press the timer reset button on the circuit board using the eraser end of a pencil or the blunt end of a plastic ink pen. Hold for three seconds. (See Figure 22) 9. Release the timer reset button. The LED on the cover will flash twice, indicating the timer circuit has been reset. 10. Close cover and tighten cover screw. 11. Afte

The treatment is a safe, silent, and proven way to make your home or office a healthier place to live and work. SAFETY CONSIDERATIONS WARNING: Never expose eyes or skin to UVC light from any source. • Looking directly at the UVC light may cause permanent eye damage or blindness. • Never operate the UV-Aire Air Purifying System with the UV chamber open. WARNING: DO NOT mount this unit outdoors. • This product is designed for indoor installation only. AFTER OPENING THE CARTON, UNPACK AND INSPECT T

En caso de un mal funcionamiento o falla de este producto, el comprador debera empaquetar toda la unidad debidamente y enviarla con PORTE PAGADO con la direccion de regreso, a la direccion indicada a continuacion. En el momento de solicitar el servicio bajo garantia, el comprador debera presentar prueba de compra que incluya la fecha de compra (por ejemplo, un recibo o una nota de venta). Si el mal funcionamiento o la falla son el resultado de defectos cubiertos por esta garantia, Field, a su ju