2. Lubricate for rust prevention. Start edging when blade rotates at full RPM, by 3. Store indoor. lowering the blade gently into the ground. Lockout Trigger Button Trigger 2. Thoroughly inspect the surface were the equipment is to be used and remove all stones, sticks, wires, bones and other foreign objects. 3. Before edging, water the area to soften the ground to make edging easier. 4. Plan to edge regularly to make it easier to keep a neat edge and to avoid making more then one pass. 5. Don’t

Desconectar! Sacar el enchufe del suministro antes de hacer ajustes, limpieza o si el cable se enreda o se dana. Mantener el cable fuera de alcance de la hoja. Peligro, cuchillas rotativas. Mantenga las manos alejadas de las aberturas de la maquina cuando este funcionando. Las cuchillas rotativas continuan girando despues de parar la maquina. Espere a que todos los componentes de la maquina se hayan parado completamente antes de tocarlos. No segar si llueve o no dejar la segadora a la intemperie

For more detailed information about recycling of this product, please contact your local council office, your household waste disposal service or the shop where you purchased the product. Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the

Customer Service Department direct Telephone : 01325 300303 Fax : 01325 302530 Safety General 1. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. Local regulations may restrict

Evite usar el trimer en pasto humedo en lo posible. 3. Tener cuidado en cesped humedo, se puede resbalar. Siempre ande, nunca corra. 4. En inclinaciones, tener mayor cuidado con los pies y llevar calzado antideslizante. 5. No caminar hacia atras mientras usa el trimer, se puede dar un traspie. 6. Mantenga el cabezal cortante por debajo del nivel de la cintura. 7. Nunca usar el trimer con las guardas danadas o sin las guardas puestas. 8. No instale nunca elementos de corte metalicos. 9. Mantener

Assembly of Switch Handle to Tube (A1) • Ensure that the internal cable is not twisted. 1. Insert the tube into the switch handle. 2. Push until it clicks into position. • ENSURE THAT THE TUBE IS FULLY LOCATED BY ATTEMPTING TO REMOVE IT. Assembly of Trimmer Head to Tube (A2) • Ensure that the internal cable is not twisted. 1. Insert the tube into the trimmer head. 2. Push until it clicks into position. • ENSURE THAT THE TUBE IS FULLY LOCATED BY ATTEMPTING TO REMOVE IT. Safety Guard Assembly (B1)

IF ANY PARTS ARE MISSING CONTACT: Flymo/Partner Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 CONTENTS 2 SAFETY If not used properly this trimmer can be dangerous! This trimmer can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this trimmer. The operator is responsible for following the warning and safety instructions in this manual and on the trimmer. Expl

Customer Service Department direct Telephone : 01325 300303 Fax : 01325 302530 instruction manual blade cover Handguard belt clip instruction manual blade cover Handguard belt clip EasiCut 420/450/500/510 EasiCut 600XT If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and ef ficiency in using this product. The operator is responsible for following

If your product is hard wired i.e. nondetachable mains electric cable, a conversion kit and extension cable is available from all Approved Service Centres which can be found in your local Yellow Pages. Assembly of Handguard. 1. Insert Handguard into slot as illustrated in figure A, ensuring that it is securely located. DO NOT USE THE PRODUCT WITHOUT FITTING THE HANDGUARD Assembly A To start your Hedgetrimmer EasiCut 420/450/510 1. There are three switch levers fitted to your Hedgetrimmer. 2. Mai

Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tools may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enabl