Votos - 3, Puntuación media: 4.3 ( )

Fabricar: Graco Inc. Tamaño del archivo: 417.86 kb Nombre del archivo: Idioma del manual:

BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LET ENGINE COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE CONTAINS FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR OPEN FLAMES WHILE PERFORMING MAINTENANCE. To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as high-temperatures or dusty conditions, more frequent maintenance checks will be required. ENGINE Refer to engine manual for the manufacturer’s recommendations for any and all maintenance. PUMP NOTE: The pump was filled with oil at the factory. 1. Change pump oil after the first ten (10) hours of operation and every fifty (50) hours thereafter. How To Change Pump Oil 1. Loosen oil fill cap. 2. Place a container under the oil drain plug. 3. Remove oil drain plug. 4. After oil is drained replace oil drain plug. Tighten securely. 5. Remove oil fill cap and fill with 30W non detergent oil. Pump capacity is 18.54 oz. 6. Replace oil fill cap and tighten securely. Oil Fill Cap Oil Drain Plug Sight Glass 13- ENG D26221 WAND If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions: 1. Shut off the pressure washer and turn off the water supply. 2. Pull trigger on gun handle to relieve any water pressure. 3. Disconnect the wand from the gun. 4. Remove the high-pressure nozzle from the wand. Remove any obstructions with the nozzle cleaning tool provided and backflush with clean water. 5. Direct water supply into nozzle end to backflush loosened particles for 30 seconds. 6. Reassemble the nozzle to the wand. 7. Reconnect wand to gun and turn on water supply. 8. Start pressure washer and place wand into high pressure setting to test. HOW TO CLEAN THE WATER INLET FILTER This screen filter should be checked periodically and cleaned if necessary. 1. Remove filter by grasping end and removing it from water inlet of pump as shown. 2. Clean filter by flushing it with water on both sides. 3. Re-insert filter into water inlet of pump. Filter Screen D26221 14- ENG STORAGE ENGINE Consult the Engine Owners Manual for the manufacturer's recommendations for storage. PUMP It is recommended that you follow these steps to protect the internal seals of the pressure washer when STORING THE UNIT FOR AN EXTENDED PERIOD and/or WHEN FREEZING TEMPERATURES ARE EXPECTED. NOTE: If storing the unit for more than 30 days *RV antifreeze needs to be run through the pump. This helps prevent damage within the pump head. *RV antifreeze is not only added for winterizing, but for proper lubrication regardless of temperature or environment. *Windshield washer fluid m...

Descargar ahora

Introduzca dos números de la imagen: