Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
The "Out" position selects the lower gain normal channel. It should be used for the cleanest sound. 6. FOOTSWITCH JACK: This Jack Is to be used with the Channel Selector/ Reverb footswltch. When this is used the SCG Channel Select switch (5) is inactive. 7. VOLUME CONTROL: This control sets the overall level of the normal channel. It must also not be at zero for the SCG Channel to function. 8. HIGH CONTROL (TREBLE): This knob affects the upper harmonic range of the guitar; clockwise (higher) settings increase the crispness or "bite" of the sound. 9. MID CONTROL: The amount of mid-range tone is set using this control. Low settings can "thin out" the sound, while higher settings can give a "fatter" sound. This control is especially useful while using the SCG channel, 10. LOW CONTROL (BASS): The amount of "bottom" or "warmth" may be increased or decreased with this knob. 11. REVERB CONTROL: This control al- lows the player to alter the apparent acoustical qualities of a room. The sound can be adjusted from very "flat" or "dry" to that of a concert hall. 12. CHORUS SWITCH: The preset stereo chorus is selected by pushing this switch to the "In" position. 13. LINE OUT JACKS: These are unbalanced line outputs which may be used to link the G20CXL/200CXL to additional amplifiers or to a tape recorder. 14. HEADPHONES JACK: Standard stereo headphones may be plugged into thisjack. Doing so disconnects the speakers, allowing private listening. A mono mix of the stereo signal is heard in the headphones. 15. POWER LED INDICATOR: When the amplifier Is on this LED is lit. 16. POWER SWITCH: Pressing the right side of the switch turns the unit on and the left side turns the unit off. POWER CORD: Your G20CXL/200CXL is equipped with a heavy-duty grounded three-wire power cord. Be sure this cord is properly plugged into a safely wired grounded 120 volt, 60 hz AC power outlet before use. (If your G20CXLV200CXL was purchased outside the United States, refer to the rear panel for power ratings|. For your safety, never attempt to defeat the ground connection on this cord. SPEAKER JACKS: (not shown, G200CXL only) These two W jacks provide 10W outputs at a minimum of 4 ohms. G20CXL/200CXL TECHNICAL SPECIFICATIONS Output Power Rating 20 watts RMS (2 x 10J (a 5% THD 4 ohm load — 120 VAC Speaker Size and Rating: Two Custom Design 6-1/2" (G20CXL only) Power Handling 20 watts RMS Low Control 18 dB range (u 80 Hz Mid Control 10dB range (ft 600 Hz High Control 20 dB range (o 6 KHz Input Impedance 280K ohms Maximum Input Signal Level Accepted 2.5 volts, peak to peak Total System Gain 105 dB Signal to Noise Ratio 70 dB Line Level Output 1.6 v p-p (a full output Headphone Level 17 mw with 8 ohm phones 1.25 v with open circuit Input Power Requirements 120 VAC, 60 Hz, 100 w max (domestic USA models] Cabinet Size and Weights G20CXL - 11-3/4 H X 17-3/4"W x 7-1/4 D 20 Jbs. G200CXL - 7-3/4 H x T 7-3/4 'Wx 7-1 /4"D 16 lbs. Specifications subject to change with...
Otros modelos de este manual:Instrumentos Musicales - G200CXL (622.51 kb)