Votos - 0, Puntuación media: 0 ( )

Fabricar: Bosch Tamaño del archivo: 3.2 mb Nombre del archivo: Idioma del manual:

Aqua sensor * * depending on model The Aqua sensor is an optical measuring device (light barrier) which measures the turbidity of the rinsing water. The Aqua sensor is used according to the programme. If the Aqua sensor is active, “clean” rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3–6 litres. If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Switching on the appliance – Turn on the tap fully. – Close the door. – Switch on ON/OFF switch (. The Cleaning display )* flashes. – Rotate programme selector 8 to the required programme. – Press START button @. The Cleaning display )* is lit. The programme starts running. en Timer programming * * depending on model You can delay the start of the programme by 3, 6 or 9 hours. – Switch on ON/OFF switch (. – Keep pressing the Preselected starting time button H until the appropriate display 3h, 6h or 9h is lit. – Press START button @, timer programming is activated. – To delete the preselected starting time, keep pressing the Preselected starting time button H until none of the displays 3h, 6h or 9h is lit. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the End display )" is lit. Note To save energy, the dishwasher automatically switches off after 2 minutes after the end of the programme. Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Turn off the tap (not applicable if Aqua- Stop fitted). – Remove the utensils when they have cooled down. a=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme – Switch off ON/OFF switch (. The LEDs go out. The programme is saved. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. – To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) – Press START button @ for approx. 3 sec. The End display )" is lit. – The remaining programme sequence lasts approx. 1 minute. Switch off ON/OFF switch (. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). en Intensive drying The final rinse uses a higher temperature which improves the drying result. The running time may increase slightly. (Caution if utensils are delicate!) – Close the door. – Switch on ON/OFF switch (. The Cleaning display )* flashes. – Press and hold down the START button @. – Rotate programme s...

Descargar ahora

Introduzca dos números de la imagen: