Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly. • Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form quickly on the evaporator. • Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. • Do not use an adapter plug with this appliance. • Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. X Warning/^ Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center. 6 ^ Reversing the Door Swing of Ynur Wine Cooler This wine cooler has the capability of either opening the door from the left or right side.The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please follow these instructions. NOTE: Before Reversing the door ,the power must be shut off. All parts removed must be saved to do the réinstallation of the door. 1. Remove the two screws(1)that hold the lower hinge{2)(right side)to the frame. Also, remove the screw-type leveling front leg(3). 2. Remove the left front leg(4) and transfer it to the right side. 3. Lift the door and place it on a padded surface to prevent scratching it. Make sure to remove the spring(5) located inside the upper right hole of the door and the upper right side pin{6). 4. Remove the plug button(7)from the upper ieft hole of the door and transfer it to the uncovered hole at the right side. Be sure to press the button firmly into the hole. Insert the upper pin(6) previously removed from the right side (step 3) and transfer it to the other hole at the left side of the top frame. 5. Insert the spring(5)previously removed(step 3)inside the upper left side hole of the door. 6. Set the door in its place making sure the pin(6)enters the bushing at the lower upper frame section(hole). 7. While holding the door in the closed position, secure the lower left hinge(2)previously removed(step 1).Before placing this lower hinge , remove the upper bolt-pin(8) and reverse the direction of the hinge. 8. Insert the bolt-pin(8)and do not tighten until the top of the door is leveled with the counter top. 9. Insert the two screws(1)previous!y removed(step 1)and tighten them. 7 FIGURE 1 {Position prior to door reversal) 3 -■ 0 FIGURE 2{Position after door reversal) (D -Door Hinge Screws (2) -Lower Door Hinge CD -Front Leveling Legs © -Left Front Leg (D -Door Frame Spring © -Door Frame Pin © -Hinge Plug{Door Frame)Left Side ® -Door Hinge Bolt IMPORTANT SAFEGUARDS Do not store food in wine cooler,as interior temperature may not get cool enough to prevent spoilage.As a natural result of condensation,in summer months or area of high humidity,the glass door may built up moisture on the outside Just wipe it away. > OPERATING YOUR WINE COOLER It is recommended you install the wine cooler in a place where the ambient temperature is between 72-78 degree Fahrenheit .If the ambient temperature in above of below the recommended temperature .conditions may-cause interior temperature to fluctuate. The range of 45-65 degree Fahrenheit may not be reached. 8 If the interior light is left on.the temperature inside the wine cooler will be higher. Recommended Temperatures for chilling Wine Red wines: 60-65 F Dry/White Wines 50-59 F Sparkling Wines 45-49 F Rose Wines 49-51 F The above temperatures may fluctuate depending on whether or not the interior bulb is on or off of whether the bottles are located on the lower/middle or lower section. > HOW TO USE THE BUTTONS ON THE DISPLAY PANEL: You can set the temperature as you desire by pushing the button T or ?.when you push the two buttons for first time,the LED readout will show the original temperature set at previous time(the temperature preset at the factory is 50’F) .The temperature that you desire to set will increase 1 ’F or 1 ’C if you push the^'once.on the contray the temperature will decrease 1‘F or 1’C if you push the^once. When you store mostly red wines, the temperature which you cantrol by pushing the above two buttons need to be set between 60 to 65 F and the LED lamp beside ,,RED"will be lit red. When you store mostly white wines,the temperature need to be set at between 50 to 59'F and the RED lamp beside "WHITE" will be lit green. When you store mostly sparkling wine the temperature need to be set at between 45 to 49’F and the LED lamp beside "SPARKLING” will be tit amber. You can s...