Votos - 1, Puntuación media: 4 ( )

Fabricar: Browning Tamaño del archivo: 813.27 kb Nombre del archivo: Idioma del manual:

Your shelves are held in place by several clips that secure them to four “tracks” on the safe interior. Some are above the shelves and some are below. To remove a clip, squeeze it together with hand pressure or adjusting the hinges. pliers and lift up. The shelves can be relocated along this track by simply relocating the clips to the desired shelf location. To replace a clip, insert the top lip of the clip into the appropriate slot in the track, squeeze the clip together and insert the bottom lip of the clip into the track. It is important that all clips supporting a particular shelf are located at the same height to ensure that the shelf sits level. Notice! The gun rack is fragile and can easily be broken when aTTempTing To remove iT or insTall iT in a new locaTion. do noT aTTempT To remove The gun rack by forcing iT ouT of The reTainer clips. remove all Top clips before aTTempTing To move The gun rack. supporT The enTire widTh of The gun rack before removing iT. faCtory installed interior lights Some safes include a factory-installed interior light package located in the ceiling of the safe. The inTerior lighT bulbs are hoT. To reduce The risk of fire, damage, or injury please noTe The following: • BulB gets hot quickly. Do not touch lens, guarD or enclosure. Touch only The power swiTch/plug when Turning on. • keep comBustiBles away from interior lights. • Do not operate the lights if DamageD, without the compleTe bulb (lamp) enclosure in place or if bulb enclosure is damaged. • Do not look Directly at lighteD BulB. • keep all items at least 3" from lighTs. failure To follow These warnings could resulT in serious injury, deaTh or cause damage To The safe or belongings. BulB rePlaCement 1 Prior to replacing a bulb, turn the light switch off and unplug the light. Allow the bulb to cool before replacing. 2 Twist lens cover counterclockwise. 3 Use only Type JCDGY8 20 watt 120 volt halogen bi-pin replacement light bulbs. Notice! do noT Touch The bulb aT any Time. use a dry sofT clean cloTh To Touch bulb while replacing. 4 Make sure the replacement bulb is installed correctly. (If you have questions contact customer service.) 6 Remove soft cloth from new replacement bulb before putting lens cover back on. 7 Replace lens cover with a clockwise motion. Care safe Body All Browning ProSteel safe paint finishes are designed for indoor use only. Use a damp rag to wipe down the surface of the safe. If something other than water is needed, a very mild soap solution may be used. However, only water should be used around the detailing areas. Care should be taken around the art scene, pinstripe, corners or logo to avoid catching and peeling any edges with the cleaning cloth. art sCene If your safe was manufactured with our exclusive art scene transfer process you must take particular care not to clean your safe with any ammonia-based cleaners. Glass cleaners like Windex® can permanently damage the art scene and other portions of the safe detailing package. Do ...

Descargar ahora

Introduzca dos números de la imagen: