Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
±10% @ 10 MHz Maximum Cable Distance: 100 meters (330 feet) 100BASE-FX CABLE SPECIFICATIONS SINGLEMODE Fiber-optic Cable Recommended: Fiber-optic Transmitter Power: Fiber-optic Receiver Sensitivity: Wavelength: Bit error rate: Maximum Cable Distance: MULTIMODE Fiber-optic Cable Recommended: Optional: Fiber-optic Transmitter Fiber-optic Receiver Wavelength: Bit error Maximum 9 .m singlemode fiber min: -15.0 dBm max: -8.0 dBm min: -32.5 dBm max: -8.0 dBm 1300nM . 10-9 20 kilometers 62.5 / 125 .m multimode fiber 100 / 140 .m multimode 85 / 125 .m multimode 50 / 125 .m multimode min: -19.0 dBm max: -14.0 dBm min: -32.5 dBm max: -14.0 dBm 1300nM . 10-9 2 kilometers Installing Slide-In-Module(s) C/E- 100BTX-FRL-03 CAUTION: Wear a grounding device and observe electrostatic discharge precautions when installing Media Converter Slide-in-Module(s) in the 16-Slot Media Conversion Center. Failure to observe this caution could result in damage to, and subsequent failure of, the Media Converter Slide-in-Module(s). NOTE: Media Converter Slide-in-Modules can be installed in any installation slot, in any order. To install the Media Converter Slide-in-Module in the E-MCC-1600 chassis: 1. Remove Media Converter Slide-in-Module protective plate from selected installation slot by removing two screws that secure plate to front of E-MCC-1600. Retain one installation screw. 2. Carefully slide Media Converter Slide-in-Module into installation slot, aligning Media Converter Slide-in-Module with installation guides. NOTE: Ensure that the Media Converter Slide-in-Module is firmly seated against the backplane. 3. Secure Slide-in-Module by installing retained installation screw. Troubleshooting 1. Is the power LED on the media converter illuminated? NO • Is the Slide-In-Module properly connected to the Media Conversion Center chasis backplane? • Is the Power Supply Module properly connected both to the Media Center chasis backplane and to the AC outlet? • Contact Technical Support at (800) 260-1312/ (800) LAN-YES • Proceed to step 2. 2. Is the 100BASE-TX Link LED illuminated? NO • Check UTP cables for proper connection (See above.) • Contact Technical Support at (800) 260-YES • Proceed to step 3. 3. Is the fiber Link LED illuminated? NO • Check fiber cables for proper • Verify that TX and RX ports, respectively, • Refer to Tech Tips • Contact Technical YES • Contact ...
Otros modelos de este manual:El receptor y el amplificador - C/E-100BTX-FRL-03 (57.72 kb)
El receptor y el amplificador - C/E-100BTX-FRL-03(SC) (57.72 kb)