Votos - 3, Puntuación media: 3.3
(
)
)
|
Resumen del manual
Unplug the stove’s power cord from the wall outlet 2. Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Unplug the 9 pin wire harness from the back of the board 5. Install the thermostat module by plugging it into the 9 pin plug on the back of the control board 6. Locate the thermostat terminal block marked T’STAT INPUT, found on the back of the module 7. Be sure to run the thermostat wires through one of the slots of the rear access panel before connecting the wires 8. Connect the 2 wires from your thermostat to the terminals on the module, 1 per terminal. Ensure the wires are firmly connected 9. Connect the 2 wires at your wall thermostat to their terminals. Ensure the wires are firmly connected 10. Reinstall the 9 pin wire harness to the 9 pin plug now found on the thermostat module 11. Reinstall the control board and the slotted rear access panels 12. Plug in the stove and you are ready to operate with your thermostat asdesredTHERMOSTAT INSTALLATION Visit for further technical assistance. Thermostat Module AcuTron Control Board Thermostat Thermostat Wire INSTALLATION STEPS Follow the thermostat manufacturer’s installation procedures TOOLS REQUIRED 1/4” hex nutsetter & driver wirestripper small sized flat head screwdriver NOTE: Always disconnect power before performing the thermostat installation 1. Unplug the stove’s power cord from the wall outlet 2. Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Unplug the 9 pin wire harness from the back of the board 5. Install the thermostat module by plugging it into the 9 pin plug on the back of the control board 6. Locate the thermostat terminal block marked T’STAT INPUT, found on the back of the module 7. Be sure to run the thermostat wires through one of the slots of the rear access panel before connecting the wires 8. Connect the 2 wires from your thermostat to the terminals on the module, 1 per terminal. Ensure the wires are firmly connected 9. Connect the 2 wires at your wall thermostat to their terminals. Ensure the wires are firmly connected 10. Reinstall the 9 pin wire harness to the 9 pin plug now found on the thermostat module 11. Reinstall the control board and the slotted rear access panels 12. Plug in the stove and you are ready to operate with your thermostat asdesred IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE The controller on your stove has been fitted with memory. Should you have a power outage or blip, the unit will come back on the setting that you had left it at before. Before you first plug in a new stove after installation, make sure you have removed all foreign objects from the hopper. When you first plug in the stove, it may possibly power up due to the initial memory test. At this time press the OFF button. NOTE: Corn stoves DO NOT USE AN IGNITER. The ...
Otros modelos de este manual:Los termostatos - Module (228.57 kb)
Los termostatos - Wire (228.57 kb)