Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Installation guidelines
Installation procedures
This installation is to be performed by qualified individuals who have
1.
Position left and right rack rails at the desired 'U' position in the
knowledge of the procedures, precautions, and hazards associated with
rack, adjusting the rails to fit the rack, as needed (1).
equipment containing hazardous electrical circuits.
2.
Secure rack rails to the front and back rack columns using screws.
Make sure that the shoulders of the screws fit inside the square or
round holes of the rack (2).
WARNING!
These rails, when installed, form only a shelf for the device to
rest on. The device is not attached to the rail by any other
NOTE:
means. Use extreme caution when pulling the device out from
If installing rails in a square hole rack, use
the rack; it can slip and fall, causing damage to the device or
larger-sized shoulder screws and pins for mounting.
injury. HP is not responsible for any damage or injury caused
If installing rails in a round hole rack, use
by the mishandling of the device.
smaller-sized shoulder screws and pins for
mounting.
WARNING!
Ensure that the rack is level and stable before working on the
rack. Be sure the leveling jacks (feet) extend to the floor and
that the full weight of the rack rests firmly on the floor.
WARNING!
Ensure that the rack has anti-tip measures in place. Such
measures may include floor-bolting, anti-tip feet, ballast, or a
combination of these as specified by the rack manufacturer and
applicable codes.
nl
WARNING!
3.
Slide the device into position on the rails (1) and then tighten the
Ensure that sufficient personnel are on hand to support the
thumbscrews on the front of the device to secure the device to the
product(s) during the installation process. Use of the appropriate
rack.
lifting device is recommended as an installation aid.
WARNING!
Always load the rack from the bottom up. Load the heaviest
items in the rack first. This makes the rack bottom-heavy and
helps prevent it from becoming unstable.
WARNING!
Do not overload the branch circuit that provides power to the
rack. The total rack load should not exceed 80 percent of the
branch circuit rating.
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
Page 2
...Otros modelos de este manual:
datos de dispositivos de procesamiento - HP D2600 Disk Enclosure/S-Buy (103.11 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 2TB 6G SAS 7.2K LFF DP MDL HDD 12TB Bundle (103.11 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 3TB 6G SAS 7.2K LFF Dual port MDL HDD 18TB Bundle (103.11 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 450GB 6G SAS 15K LFF Dual Port Enterprise HDD 2.7TB Bundle (103.11 kb)