Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
The heat output of the individual cooker plates can be regulated over a wide range with the approved seven position switch. The knobs of the appliance to be fitted underneath the hob unit as well as the knobs of the control panel for the hob unit can be switched into 6 different positions besides the "off-posi- tion“ 0. On the dial plates you find the numbers 0, III, II and I and between the numbers one dot. The dots between the numbers indicate three addational intermediate positions. You have to select these Intermediate positions when the heat output of the next higher position is too large or the heat output of the next lower position too small. The automatic cooker plates 18 and 14,5 cm diameter offer you the possibility to cook automatically. “Automatically“, that means: You put the ingredients into the pot, you switch the knob into the right position, and at the end you just take off the ready cooked meal. A special leaflet which tells you all about the operating instructions of the auto- matic cooker plates is enclosed with your tuilt-in hob unit (fig. 12). Fig. 12 If you intend to work rationally with your new buitl-in hob unit and if you want to save electricity, we would advise you in any case to switch off the cooker plate well before the meal is ready. Doing this you take advantage of the stored up amount of heat. The cooker plates of your hob unit should never be switched on whilst they are empty. Selection of Pots You can use all pots irrespective of the material, provided they have a level smooth bottom. Most suitable, of course, are special electric pots with a plain level ground bottom. The size of the pots should comply with the size of the plates. It is most economical if the diameter of the pots is approximately 2 cm larger than that of the plate. In any case the diameter of the pot should not be smaller than that of the plate. Boiling and frying with pots which are bend and only touch the plate in parts is uneconomical and leads to damage of the plates. Fig. 13: The best heat transfer can be obtained with a level pot of the same size as the plate. The use of pots and pans made from stainless steel has proved very advantageous. Pots made from aluminium with strong bottoms are very suitable for use with electric stoves in general because the conductivity of such material is very good. The use of heat resistant glass and china is also possible with the electric stove. Pot and plate should have the same diameter. To start off with you should only use position II so that the heating happens gradually. Please note that cold fluids must not be poured into hot glass or china. To continue the boiling process you may then choose a suitable low position. With our seven position switches we offer you a wide range of positions so that you can leave a meel on the plates without having to be there all the time and having in eye on it. Tabelle Switch Position Working Range 18 cm dia Quick Action Cooker Plate 18 cm dia Standa...
Otros modelos de este manual:Placas - EM 4.58 D (1.07 mb)
Placas - EM 4.58 D (1.07 mb)
Placas - EME 4.58 D (1.07 mb)
Placas - EM 4.58 D (1.07 mb)