Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
If a box or crate shows damage, then check further for concealed damage. Any shortage or damage should be reported at this time to delivering carrier. Damaged material becomes the delivering carrier's responsibility, and should not be returned to the factory unless prior approval is given to do so. When un-crating, care should be taken to prevent damage. Heavy equipment should be left on its shipping base or in its crate until moved to the final location. The packing list included with each shipment should be carefully checked to determine if all parts and equipment have been received. Electrical: The power supply (voltage, frequency, and phase) must coincide with the equipment name plate and must be in accordance with the National Electric Code, or other local codes that may apply. This is the responsibility of the user or purchaser. Electrical voltage should be checked at the compressor terminals when starting and running to assure adequate power and nominal voltage drop with actual loads. Check to insure proper: a. Wre size to handle the connected load. b. Fuses recommended. c. Proper grounding. Installation Locations: Be sure the supporting structure is level and flat and is of sufficient strength to give adequate support for the unit being installed and its contents when in use. Do not place unit where the ambient air supply to the condensing unitwill exceed 90°F. This cannot be over emphasized for long life and proper operation. This unit is designed to draw air in through the front louvers, through the condenser coil, then past the condenser body and expel the air out the back or if necessary back out the top of the louvers. Air temperature control in the cooling of all system components is of great importance. Where possible, an air path should be provided at the rear of the cabinet to expel the now used and heated air. Caring for the Interior of your Refrigerator The interior of your P. D. P. Refrigerator cabinet should be cleansed weekly. Cleansing is recommended by using a warm water soap solution and a sponge. After scrubbing the interior thoroughly, rinse with warm water. Then sanitize with a good sanitizing agent according to the manufacturer's instructions for stainless steel. Rinse thoroughly with warm water and dry. Do not leave the sanitizing agent applied to the cabinet, but rinse thoroughly and dry after sanitizing to avoid possible corrosion. This unit is equipped with a standard refrigeration compressor located to the side or bottom of the unit. In order to have efficient operation of the refrigeration compressor, the condenser coil must be kept clean. Vacuum the face of the coil regularly. The coil is located behind the front grill. The temperature dial is also located behind the front grill. It regulates the temperature of the unit from approximately 30°F to 45°F in refrigerators and -10°F to +15°F in freezers. 2 GENERAL INFORMATION (Continued) For maximum efficiency, the unit should be defrosted whenever frost layer on the interior reaches a thickness of 1 /8 inch. Never scrape the walls to remove frost. Some Tips on Food Storage in P.O.P. Refrigerated Drawers: P.O. P. Refrigerated Drawers are designed to be used as holding cabinets at the point of preparation. They are not a satisfactory substitute forwalk-in type coolers or freezers. Because of this, they should never be used to cool foods down to storage temperatures. Foods placed in the drawers should be precooled or frozen in your walk-in storage unit which has the cooling capacity for this purpose. The process of mechanical refrigeration has a natural tendency to dehydrate the air being cooled. This dry air, in turn, will tend to draw moisture from unwrapped foods. It is important, therefore, that unwrapped meats and vegetables not be stored in holding drawers for periods exceeding 24 hours. Never put more product in the drawers than will be turned over in one business day. It is a good idea to remove all pans of food from the drawers at the end of the day, cover them, and return them to the walk-in storage cooler of freezer. The result will be not only a fresher, tastier product, but you will find, that your P.O. P. drawers require defrosting less often. OPERATING INSTRUCTIONS 1. If unit has been turned on side or upside down when being removed from packaging, let stand in upright position for one hour o...
Otros modelos de este manual:Refrigeradores - POP 3S (142.66 kb)
Refrigeradores - POP 1S (142.66 kb)