Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
- Reattach the compressor cover of the refrigerator. WATER LINE CONNECTION NUT Connect the water line to the refrigerator. Secure the water line. COMPRESSOR COVER OF REFRIGERATOR -Using clip ”A”, fix the water line to the wall (the back of refrigerator). -When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed. CLIP A Complete the installation of the water supply line. -Power on the refrigerator and press the lever on the right of the dispenser until water runs out through the water line and all air has been empty. WATER LINE -At this time, check for any possible leakages at the join point in the water line. After securing the water line, move the refrigerator to the required location. Once the refrigerator is in position, do not move possibly. Install the water filter. -As shown, separate the fixed cap in the refrigerator by rotating it counterclockwise. Remove the water filter from the box and put a month indicator sticker on the filter as shown. -Write the month you installed the filter on the label. EX) If the water filter was installed in March, put “MAR” -Remove the protective cap then position and insert the filter as shown, -Slowly turn the water filter clockwise 90. to align the indication mark on the 29 INSTALLATION INSTRUCTIONS cover, locking the filter in postion. Do not overtighten. Please check if the indication line aligns with the lock position. STICKER (MONTH INDICATION) SEPARATION OF RED CAP ALIGN THE INDICATION MARK WITH LOCK POSITION. COVER FILTER CAUTION INSTALLING THE WATER DISPENSER LINE For Exterior model Connect to the water supply line Connect the water pipe with coupler and tap. -Close the main water tap. -Connect coupler “A” to the tap. -Every join should be protected with sealing tape. WARRANTY INFORMATION This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings. CAUTION The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction. COUPLER “A” TAP Select the location where the purifier is to install. (Model with the purifier) - Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap. PURIFIER WATER - If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration. COUPLER WATER INLET SIDE OF PURIFIER Line outlet SIDE OF PURIFIER 90 degree REFERENCE Remove any residual matter inside the purifier. (Model with the purifier) -Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier. -If water does not come out thr...
Otros modelos de este manual:Refrigeradores - 21KCMS (2.08 mb)
Refrigeradores - 21KCSW (2.08 mb)
Refrigeradores - 21KLDW (2.08 mb)
Refrigeradores - 21KLLB (2.08 mb)