Votos - 4, Puntuación media: 4.8 ( )

Fabricar: Dacor Tamaño del archivo: 1002.16 kb Nombre del archivo: Idioma del manual:

Interior Surfaces Exterior Surfaces IMPORTANT: 1. Turn the knobs to the “OFF” position prior to removing them from the valve stems. 2. The grill should never be operated without the knobs in place. 3. Do not soak the knobs in water or place them in the dishwasher. 4. Do not expose the knobs to direct flame, hot utensils or other sources of heat. 5. Do not use abrasive or corrosive cleaners or applicators, as these could cause permanent damage. NOTE: Cleaning stainless steel varies with each part of the grill. To assist you, please refer to the list below for the suggested cleaning procedures: 1. Stainless Steel (canopy, chassis) • Wipe with the grain • Non-abrasive cleaners or • Mild abrasive cleaners • For stubborn areas, use the Dacor Cooktop Cream supplied with the grill • “Liberally apply the cleaner to a wet sponge. For best cleaning results thoroughly rinse off all residue.” 2. Porcelain (black upper back wall) • Non-abrasive cleaners • Mild abrasive cleaners 3. Brass Burner Caps • Mild abrasive cleaners • Do not place burner caps in the dishwasher for cleaning. 4. Plastic (knobs) • Non-abrasive cleaners. (warm water with dish soap) IMPORTANT: To assist in the removal of the halogen light lens Dacor has included a pry stick. Gently slip the pry stick under the edge of the glass and pry away until the glass lifts. Remove the remaining distance by hand. NOTES: To assist you, please refer to the list below for the suggested cleaning procedures: 1. Stainless Steel (grills, heat control channels, burner box) • Mild abrasive cleaners • De-greasors (such as 409) • Abrasive cleaners (limited applications) • Dacor Cooktop Creme and wet sponge 2. Stainless Steel (u-shape burners) • Mild abrasive cleaners • Abrasive cleaners (limited applications) 3. Glass (light lens) • Non-abrasive cleaners • Glass cleaners are acceptable • Warm soapy water Troubleshooting Unnecessary service calls may be expensive, frustrating and time consuming. Before you call for service, please review the potential problems, possible causes and remedies shown in the table below. Problem 1. Nothing works.* 2. Ignitors do not spark.* 3. Sparking but no flame. 4. Burners ignite but flame is extremely large, distorted or yellow. 5. Burner flame goes out at low setting. 6. Ignitors spark continuously after flame ignition. Possible Cause Grill is not connected to electrical power. Power supply is not energized. Circuit breaker is tripped. House fuse is blown. Gas shut-off valve is in “off” position. Ports on U-burner are clogged or dirty. Ports on U-burner are clogged or dirty. Grill is being operated on wrong type of gas. Regulator is not installed, is faulty, or is set for the wrong type of gas. Low gas pressure. Air intake holes under the control panel are obstructed. Incorrect installation. Ports on U-burner are clogged or dirty at ignition location. Power supply polarity is reversed. Ignitors are wet or dirty. Low burner flame. Remedy Have grill connected to the proper electrical supply by a qualified electrician or appliance installer. Check circuit breaker, wiring, fuses, plugs, etc. Reset circuit breaker. Replace house fuse. Turn shut-off valve to “on” position. Brush U-burner with a steel brush and clear blockage with a toothpick or metal object (straightened paper clip, needle, or wire). Brush U-burner with a steel brush and clear blockage with a toothpick or metal object (straightened paper clip, needle, or wire). Ensure that the type of grill matches the gas supply (natural gas or LP). Check installation, replace regulator, or set regulator for proper gas type. Contact gas company, have incoming gas pressure tested. Remove obstruction. Check installation dimensions against installation instructions. Brush U-burner with a steel brush and clear blockage with a toothpick or metal object (straightened paper clip, needle, or wire). Have polarity corrected. Dry ignitors or clean ignitors with a metal brush to remove any residue. Contact gas company, have incoming gas pressure tested. Troubleshooting Guide * The grill burners can be manually ignited with a match or the hand spark ignitor supplied with the unit. (Refer to Manual Lighting section on page 6.) Product Maintenance No maintenance, other than the CARE AND CLEANING INSTRUCTIONS identified in this Use & Care Manual, should be attempted by the owner/operator. All other maintenance and service must be performed by a qualified appliance technician. If You Need Service... First, review the recommended checks listed in the preceding Troubleshooting Guide. Then, be certain that the appliance has been installed properly and is being operated correctly. Familiarize yourself with the warranty terms and conditions listed in the PRODUCT WARRANTY section on the inside back cover. If the above checks have been completed and the problem has not yet been remedied, call your local authorized DACOR service representative. Your dealer can normally provide the name and telephone number of the nearest...

Descargar ahora

Introduzca dos números de la imagen: