Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
2. 3. 4. 5. 6. Open the oven door with care and place in the park position at an angle of approximately 30°. Holding the oven glass with both hands, gently place the locators into the holes of the brackets at the bottom of the oven door. Push the top of the oven glass towards the oven door, ensuring the screw location holes line up. Ensure the trim is correctly positioned on the top oven / grill door. Hold the glass in place at the top of the door. Insert the cross head screws into the location holes. Give the screws one turn to ensure the glass is secure. Tighten the screws positively with a Pozidrive screwdriver before closing the oven door. DO NOT attempt to use the oven without theglass being in place. If the door glass panel becomes chipped orhas deep scratches the glass will be weakened and must be replaced to preventthe possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further. TO CLEAN THE INNER GLASS DOOR PANELS Clean the inner glass door panels using a soft cloth and hot water to which a little washing up liquid has been added. If the inner panel is heavily soiled, Hob Brite may be used. Do not use abrasive cleaning materials on the door glass. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the glass. REPLACING THE OVEN LIGHT BULB The type of bulb required is a 300°C 25 watt small Edison Screw. Part number 572 491 5431-00/1 (Available through your local Service Force Centre). CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE BULB. Open the door and remove the shelves to enable easy access to the oven light assembly. Insert a flat blade screwdriver between the oven side and glass which covers the bulb. Support the glass with your hand and prise out sufficiently to release the glass cover. Unscrew the bulb in an anti-clockwise direction until it is possible to remove the bulb with ease. Fit the new bulb by turning in a clockwise direction until it is secure. Ensuring the indent to the flange is pointing to the rear of the oven, replace the glass by pushing it firmly into the hole to cover the bulb assembly. Replace the shelves. Restore the electricity supply and adjust the time of day and clock as necessary. 31 SOMETHING NOT WORKING? SOMETHING NOT WORKING? Before calling an Engineer please carry out the The oven temperature is too high or too low: following checks, you may be able to solve the problem without the expense of an Engineer. * Check that the recommended temperatures are being used (see page 25). Be prepared If our Service Engineer finds that the problem is listed to adjust the temperature up or down by below you will be charged for the call whether or not 10°C to achieve the results you want. the appliance is under guarantee. * Care should be taken if using an oven thermometer to check oven temperatures as The grill, oven and timer do not work: they may be inaccurate. * Check that the appliance has been wired in and is switched on at the wall. The following factors should be considered. * Ensure you purchase an accurate good * Check that the main cooker fuse is working. quality instrument. If you have checked the above: * Ovens will cycle about a set temperature and will not be constant. * Switch OFF appliance at the wall and allow the appliance to cool for a couple of hours. * Switch ON again. The appliance should now If the oven is not cooking evenly. be working normally. * Check that the appliance is correctly installed The grill works but the main oven does not: and that it is level. * Check that the grill control is in the OFF * Check that the recommended temperatures position. and shelf positions are being used. * Switch OFF at the wall to allow the oven to cool. Check that the oven is now working The oven light fails to illuminate: normally. * Refer to page 31 'Replacing the Oven Light The top oven and grill work but the main oven Bulb'. does not. * Switch OFF at the wall to allow the oven to cool. Check that the oven is now working The oven fan is noisy: normally. The clock and minute minder do not work. * Check that the oven is level. * Check that the operating instructions for the timer are been closely followed. * Check that bakeware and shelves are not vibrating in contact with the back panel in the oven. The grill does not work or cuts out after beingused for a long period of time. * Leave the oven to cool for a couple of hours. Check that the grill is now operating normally. Ensure that the door is left open during grilling. * If the cooling fan fails the grill will not operate correctly. Please contact your local Service Force Centre. 32 SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the...
Otros modelos de este manual:Greeley - U20411 EPDOM (531.9 kb)