Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
If a spill (other than a sugary substance) is on the hot zone, do not clean until the unit is completely cooled down and follow the instructions below (“Cleaning for burned-on spills”). If you accidentally melt anything on the cooking or if you spill foods with a high sugar content (preserves, tomato sauce, etc.), REMOVE the spill IMMEDIATELY with a razor scraper, while the unit is still hot. IMPORTANT: Use an oven glove to protect your hand from potential burns. Scrape the major spill or melted material from the cooking zone and push into a cold area. Then, turn the unit “OFF” and allow to cool before cleaning further. After the cooking surface cools down and the heat indicator lights go off, use the daily care procedure as outlined above. Cleaning for burned-on spills Be sure that the heat indicator lights are off and the hob is cool. Remove excess burned-on substance with a single-edged razor scraper. Hold the scraper at approximately a 30° angle to the surface and scrape off the burned-on matter as you would scrape paint off of a window. IMPORTANT: Take care when using a sharp scraper. When you have removed as much as possible with the scraper clean using the daily care procedure as described above. To remove metal rub-off Sliding pans on the hob - especially aluminium or copper pans can leave marks on the surface. These marks often appear like scratches, but can be easily removed using the procedure described above for cleaning spills. If the rub-off marks are especially stubborn, use the cleaning cream together with the razor scraper, using the technique described above. Glide-out™ Grill Before you remove any of the grill parts for cleaning make sure that they are cool. The grill pan and grid should be washed in hot soapy water. After grilling meats or any foods that soil, leave to soak for a few minutes in the sink immediately after use. Stubborn particles may be removed from the grid by using a nylon brush. Alternatively the grill pan can be washed in a dish washer. To remove the grill pan support frame, pull the grill pan forward. Lift the grill pan clear of the support frame. The support frame is held to the side rails by two clips on each side. For each side, support the side rail with one hand and with the other hand lift the frame up and out of the side clips. For safety, push the side rails back into the grill chamber. The side rails can be removed to make cleaning the grill chamber easer by unhooking them from the grill chamber sides. Slides can be wiped clean with soft cloth and mild detergent. Do not use any abrasive substance. DO NOT put the side runners in a dishwasher When you have finished, hook the side rails back onto the sides of the chamber. To refit the frame pull the side rails forward and for each side in turn support the side rail and press the frame down into the side rails. Replace the grill pan. Control Panel and Doors Avoid using any abrasive cleaners including cream cleaners, e.g. Cif, on brushed Stainless Steel surfaces. For best results use a liquid detergent e.g. Domestos Multi Surface Cleaner. The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water. Wipe with a clean dampened cloth then polish with a dry cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water. The Main Oven The Main oven has panels which have been coated with a special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed. The Cook & Clean panels work better above 200°C. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200°C for about one hour. This will ensure the Cook & Clean panels are working effectively. Don’t use steel wool (Brillo) or any other materials that will scratch the surface. Don’t use oven cleaning pads. Removing the Oven Linings Some of the lining panels can be removed for cleaning and for cleaning behind. Remove the shelves first. The side panels of either oven can be removed. Each side of the oven is fixed with four fixing screws. You don’t have to remove the screws to remove the oven linings. Lift each side panel upwards and they will slide off the screws. Then pull them forwards. Once the linings are removed, the oven enamel interior can be cleaned. The Tall Oven To clean the oven sides slide out the shelves, unhook the supports from the oven sides and lift out. Moving your cooker Switch off the electricity supply. The cooker is heavy, two people may be required to move it. There are two levelling rollers at the back and also two screw down levelling feet at the front. Open the grill door and right hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the oven. Lift the front of the cooker slightly and pull forwa...