Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
12 Krell / Papa Dock PAPA DOCK SPECIFICATIONS Frequency Response 20 Hz to 20 kHz, +0, -0.15 dB <0.2 Hz to 110 kHz,+0 dB, -3 dB Signal-to-noise Ratio Wideband, unweighted, referred to full power output: >108 dB “A” weighted: >116 dB Gain: 26.2 dB Total Harmonic Distortion (THD) < 0.03%@ 1 kHz, at 150 W, 8 Ohms < 0.20%@ 20 kHz, at 150 W, 8 Ohms Input Impedance 90 kOhms Input Sensitivity 1.70 Vrms Output Power, each channel driven: 150 Wrms @ 8 Ohms 300 Wrms @ 4 Ohms Output voltage 98 V peak-to-peak, 35 Vrms Output current: 15 A peak Slew Rate: 50 V/.s Output Impedance <0.073 Ohms at 20 Hz <0.084 Ohms, 20 Hz to 20 kHz< Dampening Factor 110 at 20 Hz, referred to 8 Ohms 95, 20 Hz to 20 kHz, referred to 8 Ohms Power Consumption Stand-by: 25 W, Idle: 55 W, Maximum: 900 W Heat Output, BTU/hr. Stand-by: 85, Idle: 190, Maximum: 1100 Inputs 1 40-pin KID connector 1 RS-232 (to control KID) via a 9-pin D-subminiature connector Outputs 2 channel via 5-way binding posts Remote Connectors One 12 VDC output (12 V trigger), 30 mA maxi mum, via a 3.5 mm connector S-Video (from KID) via mini-DIN connector 1 composite video (from KID) via RCA connector Dimensions Inches: 17.3 W x 5.7 H x 16.3 D Centimeters: 43.8 W x 14.5 H x 41.3 D Weight Unit Only: 39 lb., 17.6 kg Shipped: 49 lb., 22.2 kg Your KID product serial number is: P/N 301038 v 08.0 Krell Interface Dock Papa Dock Owner’s Reference POWERPOWERBASSTREBLEVOLUMEAUXINPUT Krell / Papa Dock Owner’s Reference, v 08.0 CONTACT INFORMATION IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions. 2. Keep these Instructions. 3. Heed all Warnings. 4. Follow all Instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8. Unplug this apparatus during lightning storms or when unused for long periods of time. 9. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as a power- supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 2 Krell / Papa Dock Krell Industries, Inc. 45 Connair Road Orange, CT 06477-3650 USA TEL 203-298-4000 FAX 203-891-2028 E-MAIL krell@krellonline.com WEBSITE 10. The KID and the Papa Dock must be placed on a firm, level surface where it is not exposed to dripping or splashing. 11. The ventilation grids on the bottom of the KID, and the ventilation grids on the top and bottom of the Papa Dock must be unobstructed at all times during operation. Do not place flammable material above or beneath the KID or the Papa Dock. 12. Before making connections to the KID or the Papa Dock, ensure that the power is off and other components are in mute or stand-by mode. Make sure all cable terminations are of the highest quality, free from frayed ends, short circuits, or cold solder joints. 13. THERE ARE NO USER SERVICEABLE PARTS INSIDE THE KID OR THE PAPA DOCK. Please contact Krell if you have questions not addressed in this guide. These products comply with the EMC directive (89/336/EEC) and the low-voltage directive (73/23/EEC). Krell® is a registered trademark of Krell Industries, Inc., and is restricted for use buy Krell Industries, Inc., its subsidiaries, and authorized agents. iPod is a trademark of Apple, Inc., registered in the U.S. and other Countries. © 2008 by Krell Industries, Inc. All rights reserved. Front Panel and Remote Control Functions for the KID TOP AND FRONT PANEL ONLY 22 iPod-device docking station Connect the iPod-device to the KID by plugging it into the dock connector. The iPoddevice takes the KID in and out of stand-by. When an iPod-device is connected to the dock connector, the KID automatically moves to the operational mode from stand-by. FRONT PANEL AND REMOTE 24 Power Button Press the power button or key to take the KID in and out of stand-by. Power LED Color Guide When the KID is plugged into AC power, the power LED illuminates: Red The KID is in stand-by mode. Blue The KID is on, in the operational mode, indicating that an iPod-device is connected. Purple The KID is on, in the operational mode, and an iPod-device is not connected. 25 Bass Control Two buttons or keys control the bass tone control + or - 6 dB. The bass control is within the KID and not in the iPod-device. REMOTE ONLY 28 DISP Key Turns on the iPod-device backlight. 29 Menu Key Activates the iPod-device menu function. The remote menu key does not have a held function. 30 Up Directional Key Performs the iPod-device up arrow function. 31 Down Directional Key Performs the iPod-device down arrow function. 32 Left and Right Directional Keys or Track Keys Activate the iPod-device previous and next track functions respectively. 33 Play Key Performs the iPod-device play/resume function. 34...