Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
The main left and right speakers feature magnetic shielding, allowing placement near any sensitive electronic devices. The Product Development Team at Cambridge SoundWorks believes there is no better combination of audiophile-level attention to detail and reasonable cost. Inspecting For Damage Examine the speaker system carefully for shipping damage. If there is any, do not install or use the system. Return the speaker to the store where you made the purchase or call Cambridge SoundWorks at: 1-800 FOR-HIFI (1-800-367-4434) for assistance. After Unpacking Store the shipping carton and packing material for future transport needs. QUICK SETUP If you have connected amplified subwoofer/satellite systems before, the Connection Diagram on pages 8-9 may be all you need to get set up and operating. 4 CARTON CONTENTS A) Two Satellite Loudspeakers B) Desktop Stands,Thumb screws (installed on satellites) C) Wallmount hardware, Self-adhesive Feet A D) Hook and Loop fastener (for volume control, if not used on Desktop Stand) E) One Subwoofer/Amplifier Loudspeaker F) Power Adapter (AC to AC) G) Volume On/Off Control B H) 2 Satellite Connection Cables (2-meters) C No.10 screws and plastic anchors Rubber Feet E F G H D Green to signal source Blue to subwoofer 5 SETUP OPTIONS Cambridge SoundWorks, Inc. supplies screws and plastic anchors for convenience, but it is the speaker purchaser’s responsibility to insure that any speaker mounting or placement is secure, stable and reliable. Cambridge SoundWorks assumes no responsibility for damage to its products or any damage to property resulting from speaker positioning or placement. SUBWOOFER/AMPLIFIER The Subwoofer/Amplifier requires no assembly. SATELLITES Desktop Placement Each satellite is shipped with a Desktop Stand installed. You can also mount the Volume Control to a Desktop Stand (see page 12). Shelf Placement (or other flat surface) without the Desktop Stand A) Desktop Stand Removal: unscrew the thumbscrew to release the satellite. B) Apply the soft, self-adhesive feet to the bottom surface of each satellite, as shown. Wall Mounting With Supplied Hardware Note: Use the “hook and loop” fastener to secure the volume control to a convenient flat surface if not using the Desktop Stand C) Apply the soft, self-adhesive feet to the back of the satellite as shown. The feet provide mounting stability and protect the finish of both the wall and the satellite. D) Install the No.10 screw and anchor in the wall so that its screwhead protrudes about 3/8 inch. E) Adjust the screw so each satellite can be hung with just a small amount of pressure. A B Apply Feet to Bottom for Flat Surfaces C Apply Feet to Back for Wall Mounting on Screwhead D E Install Mount Speaker 6 Wall Mounting With A Swivel Bracket Contact Cambridge SoundWorks about available swivel brackets. F) Follow the installation instructions for your particular mounting bracket to attach it to a flat surface. If desired, you can install the whole bracket/satellite assembly inverted. This places the bracket above the satellite, concealing it when viewed from below. In this case, remove, invert and re-install the the F satellite grille to position the logo correctly. Remove, Invert and Replace Grille Panel Floor Stands G G) Follow the instructions included with the Newton ST300 Floor Stands to install the satellites. Using Speakers on a Stand 7 CONNECTION DIAGRAM Right Speaker AUDIO OUT Computer sound card Insert the greenminiplug into your primary music source’s stereo minijack output (a sound card, a stereo TV or a Cambridge Connect a second sound source with a variable output to INPUT B. MusicWorks RED Connect the blueminiplug to INPUT A. MicroWorks II Volume Control Headphones connect to the Volume On/Off control Portable Playe 8 888 Left Speaker R L--+ + RED MicroWorks II Subwoofer Input Panel RED RED Music er 9 POSITIONING YOUR SPEAKERS SUBWOOFER/AMPLIFIER Place the Subwoofer cabinet on the floor, preferably near a wall. Do not place it on a desktop or shelf. For the most efficient bass performance, place the subwoofer near a corner. If the subwoofer is placed away from the intersection of two room surfaces, the maximum bass output will be reduced. Use the Bass Level control to adjust the bass output to your desired balance. Recommended Bass control settings for each type of location are shown. Maximum Bass Output Moderate Bass Output Least Bass Output Suggested Bass Control Compensation SATELLITES Desktop Placement The Desktop Stands improve the sound for both a standing or seated listener. Position the satellites so they form a 45 degree angle from your listening position. 45°angle MusicWorks 45°angle 10 101010 POSITIONING THE SATELLITES Wall Placement (Swivel brackets available separately) Avoid facing a satellite parallel to a nearby wall (within 6-8 inches). The reflected sound from the wall degrades the sound coming directly from the satellite (diagram A). Try to position wall-mounted satellites so both are approx...