Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original purchase date will be required before warranty repairs are provided. Mail in service can be obtained during the warranty period by calling (800) 840-0288 toll free. A Return Authorization number must be obtained in advance and can be marked on the outside of the shipping carton. This warranty gives you specific legal rights and you may have other rights (which vary from state to state). If a problem with this product develops during or after the warranty period, please contact Channel Vision Technology, your dealer or any factory-authorized service center. Channel Vision 234 Fischer Avenue, Costa Mesa, California 92626 USA (714)424-6500 * (800)840-0288* (714)424-6510 fax email: techsupport@channelvision.com 500-008 rev C1 INSTRUCTIONS SÛT m ID652 6.5” Dual Voice Coil In-Ceiling Speaker 0Channel Vision™ ©2008 CHANNEL VISION TECHNOLOGY Model ID652 1 1 IF screws (4) Installation: • Cut 8” hole in drywall away from ceiling joists. • We recommend wiring with AWG 16 or larger, stranded wire. • For proper phasing, both voice coils must be wired alike. Connect red wires to red terminals on speaker and to red or plus terminals on amplifier. • Install ID652 in hole. Tighten the mounting screws. The mounting dog ears will rotate outward and grip the drywall. • Aim tweeters • To control the volume of the speaker locally, use an impedance matching volume control, such as the Channel Vision VC302. Features: Dual voice coil speaker delivers stereo sound from a single speaker Use when only one speaker will fit or to balance coverage in a whole house audio system Use in bathrooms, hallways, entry ways Mica-filled polypropylene woofer with true rubber surround Dual Vz fluid-cooled ultra-wide dispersion mylar tweeters Tweeters swivel independently up to 45 degrees Tweeter protection using thermal sensing polymer switches Dual 2nd order Butterworth crossover networks Recommended power: 5W to 90W Specifications: Frequency range: 55Hz - 20kHz ± 3dB Sensitivity: 89dB (for 2.83V pink noise) Power Handling: 65 Watts RMS (92 Watts Peak) Drivers: 2- Vi' Mylar dome tweeter 1- 6 /4” polypropylene woofer Impedance: 8 ohms Finish: ABS plastic Dimensions: 9%” OD. 31/2” height (from surface of wall board) Weight: 5 Lbs as shipped Specifications subject to change without notice....