Votos - 4, Puntuación media: 3
(
)
)
|
Resumen del manual
28 29 continued on next page. 4358-3340A 4 5 6 7 11/15/04 9:18 AM Page 33 Push LATCH hook through the rear-facing belt path slot. Pull other end of LATCH hook under pad in front of crotch strap to the opposite side. Do not place LATCH belt over child’s legs. Push LATCH hook through the other rear- facing belt path slot. Put seat pad back over corners of shell. Completed threading of the LATCH system. 30 1 2 Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm). Rear-Facing Installation LATCH: Install in Vehicle Place child restraint rear- facing in the back seat. NOTE: Tuck the top anchorage strap’s hook under the child restraint. Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle owner’s manual for more information. Push down firmly on the child restraint and pull up on the loop to tighten belt. NOTE: In some cases, you may need to pull the pad off the front corner and expose the belt path. Tighten belt through belt path slot. Replace pad on corner. 31 continued on next page. 4358-3340A With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the LATCH belts do not loosen, your child restraint should be secure. NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If the child restraint does not remain tight, do not use the child restraint in this seating location with this LATCH system. 3 11/15/04 9:18 AM Page 35 Forward-Facing Use: 20-40 lbs. (9-18 kg), 29-40” (73-102 cm), Over 1 year of age. Forward-Facing Use Lap/Shoulder Belt LATCH Belt Lap Belt WARNING: ! Using this child restraint in any vehicleseat where the lap or LATCH belts cannotbe tightened securely and properly orwhere it can be loosened by pulling on itcan result in serious injury or death. For vehicles with an air bag, but without aback seat, refer to your vehicle ownersmanual. 33 Refer to the Weight and Height Chart to make sure your child is at the proper weight and height to face forward. 4 After checking for hot seat and buckles, place infant in child restraint. See “Securing your child in the child restraint” section. 5 To remove LATCH: Remove child from child restraint. Press down firmly on adjuster side of child restraint and press release button to release tension. Unhook LATCH from bar by squeezing spring lever and twist hook. WARNING ! Loose LATCH hooks could cause serious injury or death. Using this child restraint in any vehicle seatwhere the LATCH belts cannot be tightened securely and properly or where itcan be loosened by pulling on it can resultin serious injury or death. 32 4358-3340A 11/15/04 9:18 AM Page 37 Forward-Facing Installation After deciding whether to use Vehicle Belts or LATCH, be sure to read the warnings below as they pertain to both systems. You may need to remove the base for narrow vehicle seats or airline use. See “Removing Base” in Belt- Positioning Booster section. NOTE: To install the child restraint without the base, rotate recline stand down and out, then push up to lock. When LATCH is not being used, fasten belt hooks together behind the child restraint as shown. WARNING: ! Loose LATCH hooks can result in serious injury or death. 34 Forward-Facing IVehicle Belts: nstallation with 1 Face child restraint forward in the vehicle seat either in the reclined or upright position. Thread the vehicle lap belt or lap/shoulder belt combination through the belt path and out other side. Buckle. Place one knee in the child restraint and push down firmly while pulling up on belt to tighten. For a manual belt, refer to “Knowing your Vehicle Belt” section. Connect top anchorage strap to the anchor bracket. To Adjust and other top anchorage strap information: See “Adjusting Top Anchorage Strap” section. NOTE: If your vehicle2 3 does not have an anchor bracket, tuck the topanchorage strap andhook under the base or child restraint. 35 continue on next page. Forward-Facing Use: 20-40 lbs. (9-18 kg), 29-40” (73-102 cm), Over 1 year of age. 4358-3340A 11/15/04 9:18 AM Page 39 4 5 With weakest hand at the belt path, tilt and push the child restraint from side to side. If the LATCH belts do not loosen, your child restraint should be secure. NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing Your Vehicle Belts” and “The Locking Clip” sections. After checking for hot seat and buckles, place your child in the child restraint as described in the “Securing Your Child in the Child Restraint” section. WARNING ! Using this child restraint in any vehicle seatwhere the lap belt cannot be tightenedsecurely and properly or where it can beloosened by pulling on it can result inserious injury or death. 36 Forward-Facing Installation LATCH Belt: Install Belts 1 2 NOTE: Do not use LATCH system along with the adult lap or lap/shoulder belt. Route LATCH belt through upper slot in sid...