Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
LINE UP LOCATING TABS AND CAREFULLY MATE CONNECTORS. INSTALLATION INSTRUCTIONS FOR THE CDC-TO2: (See Installation Diagram) 1. Mount the CD Changer in the rear of the vehicle. Refer to the installation instructions supplied with the CD Changer. 2. Be sure the ignition switch and the radio are in the off position. CAUTION: If not, the radio will not recognize the changer. 3. Remove the factory radio from the dash panel. 4. Disconnect the power/speaker harness between the car and the radio. 5. Connect the CDC-TO2 to the Changer using the 5 Meter DIN Cable supplied with the CD Changer. 6. Plug the 12 Pin Connector from the CDC-TO2 into the mating socket on the rear of the factory radio. 7. Re-connect the radio power/speaker harness. 8. Reset the Changer and insert the CD magazine. 9. Re-install the radio into the dash panel. 10. Turn on the ignition and radio and perform an operation check. OPERATION CHECK: 1. Load CD’s into the CD Changer magazine and insert the magazine into the changer. 2. Start vehicle and allow CD Changer to cycle. Perform a brief functional test to verify proper operation according to the Owner’s Manual. © 1998 Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 CDC-TO2 FACTORYRADIO REARVIEW ANTENNAJACKS 12-PIN CD CHANGER CONNECTOR 15-PIN SPEAKER/POWER CONNECTOR 12-PIN CONNECTOR 8-PIN DIN CONNECTOR SPEC/M PERFORMANCE SER/ES Model: CDC-TO2 CD CHANGER INTERFACE FOR TOYOTA VEHICLES Audiovox Corporation, Hauppauge, NY Made in Taiwan PROD. CODE: 000 5 METER DIN CABLE (SUPPLIED W/ CD CHANGER) 10 DISC CD CHANGER SPECIAL 'PERFORMANCE ’SER/ES ------o3...