Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Press button PROGRAM to save selected track. 2. Repeat steps 1 and 2 for programming last tracks (maximum 20 of them). After programming is complete, symbols «PROGRAM - - -» are blinking on LCD. Notice: At pressing buttons FOLDER <>, number of the last programmed folder is indicated on LCD. 3. Press button PLAY/PAUSE to start playback, playback indicator .and program mode symbol «PROGRAM» are indicated on LCD. 4. In playback stop mode press button PROGRAM to view the programmed tracks, symbols «P01» are blinking on LCD. Press buttons FOLDER <> to view the folder, and press button SKIP/SEARCH to view the tracks. Press button PROGRAM once more, symbols «Р02» are blinking on LCD. Repeat these steps to view the next tracks. 5. In playback stop mode press button STOP or open disc compartment cover to cancel the programmed playback. Program mode symbol «PROGRAM» disappears. Notice: This appliance plays majority of discs burnt in MP3 format. However, sometimes discs cannot be played back because of software settings used to burn the disc. Troubleshooting Inappropriate usage often causes malfunctions and noise. If you suppose that something is wrong with the appliance, check the possible causes of malfunction described in table below. If you cannot fix the malfunction, apply to the nearest authorized service center or to nearest dealer for repair. Malfunction Possible cause Action No sound Volume level is zero Adjust volume level No power Check power source LCD malfunction Electrostatic charge Switch the appliance off, wait for some time, and switch it on again Noise while listening to FM or AM band stations Station is not tuned FM band: antennae is not pulled out AM band: the device is out of reception area or in area of unstable reception Tune the station Pull out antenna Try other locations The appliance does not play stations of FM or AM band RADIO mode is off Set operating mode switch to RADIO position No disc indication/no disc playback Disc playback mode is off Switch on disk playback mode No disk or the disk is not installed in correct way Adjust disk position, its label should be up CD-R is empty or it is not finalized Use finalized CD-R There is condensation on optic system Wait for some time Separate tracks cannot be played back Disc is scratched or dirty Wipe disc with soft cloth, do not used damaged disks Disk is inserted, but the tracks cannot be played back Disk is not inserted correctly Adjust disk position, its label should be up Disc is scratched or dirty Wipe disc with soft cloth, do not used damaged disks Inadequate disc format Use discs of proper format Delivery set: Player – 1 item Power cord – 1 item Technical specifications Power AC 220 -230 V, ~50 Hz Operation by batteries (not included in delivery set): Player 8 batteries of R14/C type Dimensions, mm 277x 207x 123 mm Output power (nominal) 1,5 W х 2 Speakers 2 х 3 W, 8 Ohm Disk loading type upper CD Frequency band 100 Hz – 10 kHz Signal/noise ratio 50 dB FM Frequency band 64 – 108 MHz Intermediate frequency 10,7 MHz Antenna telescopic AM Frequency band 540 – 1700 kHz Intermediate frequency 455 kHz Antenna ferrite, built-in The manufacturer reserves the right to change the design and specifications of the unit without preliminary notice. Service life period of this unit is no less then 3 years. Recycling of electronic and electrical appliances (Used in the EU countries and other countries in Europe with selective sorting system) This product is marked by the symbol of the selective sorting, relating to the electrical and electronic component scrap. That means that the product must be taken by a selective system of collection in order to reduce any environmental impact. The electronic products not having been the subject of a selective sorting are potentially dangerous for the environment and human health because of the potential presence of dangerous substances. For details apply to the service dealing with recycling or to the shop where you bought the product. Guarantee Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Law Voltage Regulation (73/23 EEC) РУССКИЙ 11 Магнитола CD/МР3 VT-3952 ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ Перед подключением, использованием или настройкой устройства внимательно прочитайте инструкцию. Необходимо соблюдать все предупреждения и рекомендации по эксплуатации устройства, приведенные в этом руководстве. Сохраните руководство, используйте его в дальнейшем в качестве справочного материала. ВНИМАНИЕ! Опасность удара электрическим током! НЕ ВСКРЫВАТЬ! Предупреждение: во избежание возникновения пожара или поражения электрическим током не подвергайте устройство воздействию дождя или влаги. Чтобы избежать удара электрическим током, не открывайте корпус устройства с...