Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
(It may not be possible to play certain DivX disc due to the configuration and characteristics of the disc or condition of the recording). 16 General operation Power button Press POWER button on the front panel or any other button on the panel except EJECT to turn on the unit. Press POWER to switch the set to POWER OFF. When you switch off the system or car ignition, the settings, tuner presets and the volume level will be retained in the unit's memory. Mode Selection Press the MODE Button to cycle the Play Mode between RADIO and DISC PLAY. Press and hold the MODE button to activate the AUX mode. Volume knob button Push the VOLUME-UP/DOWN/ SEL control to select VOL/BAS/TRE/BAL/FAD, rotate the control to adjust. - VOLUME control Display shows the volume level VOL. - BASS control (will be available when DSP is OFF) Display shows the BASS level - TREBLE control (will be available when DSP is OFF) Display shows the TREBLE level - BALANCE control Display shows the BALANCE level - FADER control Display shows the FADER level Mute Press the MUT Button to activate the Mute function. Press MUT Button again or use the VOL +/ - Button to cancel. Loudness control Press and hold EQ/LUD to select LOUDNESS on or off. LOUD ON or LOUD OFF appears on the display. Press it again to cancel 17 Adjusting clock Setting the clock time 1. Press and hold CLK for more than 3 seconds to select the hour setting. Hour digits will blink. 2. Rotate the control to set the hours. 3. Press VOL knob to select the minute setting. Minute digits will blink. 4. Rotate the control to set the minutes. 5. Press CLK Button, or leave the unit idel. Time setting is now confirmed. Reset Press EJECT to open the panel and press the RESET hole to restore the unit to the original factory settings. Preset Equalizer Function Press the EQ/LUD Button repeatedly to choose the EQ sound effects. The Sequence of equalizer setting will be as follows: CLASS - POP - ROCK - FLAT - OFF 18 Digital tuner Choose Radio Band Press the MODE Button to access the radio function. The unit comes with five bands- three FM Bands (FM1, FM2, and FM3) and two AM Bands (MW1, and MW2). Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations. Radio Tune / Seek Function In Radio Mode, press right tuning knob (Seek +/- Button) to manually adjust the radio frequency. Turn it clockwise for manual seek +, and anti-clockwise for manual seek -. Turn and hold the Seek +/- button for more than 1 second, the radio will seek to the next up or down strong and clear frequency station. Repeat this action to seek for other desired stations. Mono/Stereo Reception Control In FM radio mode, press the "MON/ ST" button to select stereo or mono reception. "ST ON" will show on the display indicating that stereo reception is received. Improvement of reception of distant stations can be done by selecting "MO/ST" operation which may cut down some reception noise. Local/Distance Control In radio mode, press the "LOC" button to select local or distance reception. a. "LOC ON" showing on the display, means local reception is turned on; b. "_DX_" showing on the display, means distant reception is turned on. Local and distance reception setting can facilitate the radio reception, depending on the location in which the radio is being used. Save Your Preset Stations There are six numbered preset buttons which can store and recall stations for each band. While listening to a radio station you would like to save as a pre-set, press and hold one of the buttons numbered 1-6 until you hear a beep. The button you pressed is now the pre-set button for that station. 19 Automatic Store/Preset Scan A. Automatic Scan & Store While listening to the FM Radio, press and hold the APS Button for 3 seconds. The receiver will automatically scan and save stations for all the 3 FM Bands, whichever band (FM1, 2 or 3) you are listening to. While listening to the AM Radio, press and the APS Button for 3 seconds. The receiver will automatically scan and save stations for the 2 AM Bands, whichever band (MW1 or 2) you are listening to. B. Scan Saved Stations Press the APS button or the AMS button on the remote control once to perform the scanning functions. In FM mode, press the APS button or the AMS button and the stations in that FM band will be scanned; press the button in AM mode and scan the band stations of that AM Band. 20 DVD/VCD/CD/MP3/CD-R Discs for playback • This set can play all digital audio CD, HDCD, CD-R/RW, MP3,WMA, VCD, SVCD, DVD, DVD-ROM. • The following file types are supported: Audio files: MP3 (*.mp3) WMA (*.wma) Video files: MP4 (*.avi, DIVX3.11/4.0/5.0/6.XX and XVID) MPEG 2(*.vob) MPEG 1(*.dat) Picture file: JPEG (*.jpg) • ISO 9660 or ISO 9660 +Joliet format - Max. 30 characters • Max. Track number is 448 • Max. nested directory is 8 levels • The max. album number is 99 • The max. length of each track is 99...