Iniciar sesión:
Votos - 0, Puntuación media: 0 ( )

Manual de usuario Sony, modelo CDX-M800

Fabricar: Sony
Tamaño del archivo: 2.5 mb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Otros manuales para este modelo:
Unidad - CDX-M800 (3.06 mb)fr
Unidad - CDX-M800 (686.86 kb)en
Unidad - CDX-M800 (500.33 kb)de

Resumen del manual


Code Del display OK: returns to a normal display. NG: the “Code Error” message appears. Input the correct code using the cursor buttons. Note You cannot change the security code unless you delete your stored code. Tip If the security code is not stored, the Code Del display does not appear. Additional Information Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Fuse (10 A) Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Replacing the lithium battery Under normal conditions, batteries will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion. x + side up Notes on lithium battery • Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. • Wipe the battery with a dry cloth to assure a good contact. • Be sure to observe the correct polarity when installing the battery. • Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire. Removing the unit 1 Remove the protection collar. 1Engage the release keys together with the protection collar. Orient the release key correctly. 2Pull out the release keys to remove the protection collar. 2 Remove the unit. 1Insert both release keys together until they click. Face the hook inwards. 2Pull the release keys to unseat the unit. 3Slide the unit out of the mounting. Specifications CD Player section Signal-to-noise ratio 90 dB Frequency response 10 – 20,000 Hz Wow and flutter Below measurable limit Tuner section FM Tuning range 87.5 – 108.0 MHz Aerial terminal External aerial connector Intermediate frequency 10.7 MHz/450 kHz Usable sensitivity 9 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 67 dB (stereo), 69 dB (mono) Harmonic distortion at 1 kHz 0.5 % (stereo), 0.3 % (mono) Separation 35 dB at 1 kHz Frequency response 30 – 15,000 Hz MW/LW Tuning range MW: 531 – 1,602 kHz LW: 153 – 279 kHz Aerial terminal External aerial connector Intermediate frequency 10.7 MHz/450 kHz Sensitivity MW: 30 .V LW: 40 .V Power amplifier section Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 – 8 ohms Maximum power output 52 W . 4 (at 4 ohms) General Outputs Audio outputs (front/rear) Subwoofer output (mono) Power aerial relay control terminal Power amplifier control terminal Inputs Telephone ATT control terminal Illumina...


Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría