Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Down the C- pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 6. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. FIGURE 6 II. INSTALLATION OF CONSOLE IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED. 13. Raise console (item 6 pg.2) into approximate position against headliner. Loosely install using (2) two 6-32 x 3/4" screws (item 1 pg. 2) through the smaller holes in bracket on console into threaded clips on front of mounting bracket. See Figure 7. 14. Using a scribe or similar tool, align hole in rear of console with slot in rear of mounting bracket. Loosely secure rear of console using (1) one # 8 x 1 1/2" screw (item 3 pg. 2). Make sure console alignment is straight then tighten (2) two 6-32 screws previously installed. See Figure 7. FIGURE 7 5 15. Release video screen from locked position. Lower video screen to viewing position for access to mounting location in top of video system housing. 16. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instruction included with video system. 17. Check function of all component and lights. See operating instruction for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. FIGURE 8 18. Insert video system into opening in console. Note : Make sure wires do not get pinched between video system and console. Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32x 3/4" screws (item 1 pg.2) and (4) four 3.5mm washers (item 3 pg. 2). See Figure 8. Caution : Do not overtighten screws. FIGURE 9 19. Tighten screw previously installed to secure rear of console to headliner. Caution: Do not overtighten screws or damage to vehicle roof may occur. 20. Raise video screen into locked position. 21. Install speaker grille (item 7 pg. 2). Align clips in grille with holes in console and press firmly. See Figure 9. 22. If speaker upgrade kit was not installed, install cover plate (item 8 pg. 2) at front of console and secure using (2) # 6 X 1/2" screws (item 4 pg. 2). 23. Install cover plate decal (item 9 pg 2). 6 ...
Otros modelos de este manual:Vídeo del coche - 50-0300A-002 SERIES (584.1 kb)