Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
. Then attach the Velcro strips to the rear of the monitor, and push the frame onto the headrest. Take care not to press the screen itself, and apply pressure only in the region of the frame. Example of a direct connection to a DVD player Adapter cable for a direct connection to an AV source DVD - Player (IVDP-01) Video outAVDigital inout Audio L outAudio R out Masse/GND +12V IVMS 5802/6502 Positive connection Connect the fuse holder to protect the positive cable (+12 V). The fuse holder should be connected to the positive terminal at a distance of max. 30 cm from the vehicle battery (if necessary, drill a hole in the bulkhead and use the appropriate cable grommets). FITTING REMOVAL Negative (ground) connection Attach the negative cable (earth/GND) directly to the vehicle body using a screw. Scratch the surface down to the bare metal at the point at which the ground is made. • If the installation requires holes to be drilled or any other changes to be made to the vehicle, please contact a specialist workshop in your area. Removal . To remove the screen, insert the extraction tool between the screen and the mounting plate. . Insert the extraction tool at the place where a slot has been provided between the screen and the mounting plate. ENGLISH Extraction tool 21 OSD MENU OSD menu Operation . Press the “MENU” button on the display or on the remote control to open the OSD menu. . Use the arrow buttons / to select the options and after you press the MENU button you can use the arrow buttons / to change the settings. . Press the “EXIT” option to close the OSD menu again. ZOOM BRIGHTNESS CONTRAST COLOR TINT REVOLVE LEFT-RIGHT UP-DOWN RESET PICTURE EXIT . ZOOM (picture size): Change the picture height/width -FULL -NORMAL -WIDE . BRIGHTNESS To adjust the brightness . CONTRAST: To adjust the contrast . COLOR: To adjust the colour . TINT: To adjust the picture shade (only for NTSC) . REVOLVE: To revolve the screen display -LEFT - RIGHT Horizontally mirrored -UP - DOWN Vertically mirrored . RESET PICTURE: To reset the configured parameters to the factory default settings. . EXIT: To close the OSD menu IR REMOTE CONTROL IR remote control Functions The supplied remote control is suitable for operating the following monitors: IVMS-5802 and IVMS-6502. 1 2 3 1 POWER On/off button for the monitor. 2 TV/VIDEO No function. 3 VOL • arrow button Increase the volume for the selected monitor. VOL • arrow button Decrease the volume for the selected monitor. 4 MUTE Mute the volume of the loudspeakers inside the monitor. 5 CH • arrow button / Channel selection if the monitor is connected to a signal controller IVSC-3302 or IVSC-5502. 4 5 6 IVRC-06 MUTETV/VIDEOPOWER VOL CH MENU Caution: The way the CH buttons function depends on the monitor selection (which is made using the signal controller’s remote control). 6 Menu See OSD menu, operation (page 22). / ENGLISH 23 SPECIFICATIONS Specifications 5.8" screen System: NTSC/PAL auto switch Power supply / consumption: 12 V direct current, ± 10%, <900 mA Standby: < 1 mA Video input level: 1 Vpp, 75 ohms Audio input level: 0 - 0.3 Vrms, 20 Hz - 20 kHz Operating temperature: -20° C to +60° C Storage temperature: -30° C to +80° C Screen size (diagonal): 5.8" (14.7 cm) Contrast ratio: 60 Power consumption: < 11 W Brightness: 300 cd/m2 Display technology: TFT active matrix system Resolution (pixels): 1200 (H) x 234 (W) = 280,800 pixels Visible screen area: 127.20 (W) x 71.84 (H) mm Viewing angle: From the left and right: 60°, From above: 60°, From below: 30° Total monitor dimensions: 165 (W) x 122 (H) x 26.7 (D) mm Monitor weight: < 400 g SPECIFICATIONS 6.5" screen System: NTSC/PAL auto switch Power supply / consumption: 12 V direct current, ± 10%, <900 mA Standby: < 1 mA Video input level: 1 Vpp, 75 ohms Audio input level: 0 - 0.3 Vrms, 20 Hz - 20 kHz Operating temperature: -20° C to +60° C Storage temperature: -30° C to +80° C Screen size (diagonal): 6.5" (16.5 cm) Contrast ratio: 60 Power consumption: < 10 W Brightness: 280 cd/m2 Display technology: TFT active matrix system Resolution (pixels): 1200 (H) x 234 (W) = 280,800 pixels Visible screen area: 142.80 (W) x 87.70 (H) mm Viewing angle: From the left and right: 60°, From above: 60°, From below: 30° Total monitor dimensions: 176.0 (W) x 122 (H) x 26.7 (D) mm Monitor weight: < 400 g ENGLISH Subject to changes! 25 Beispielanschluss mit verschiedenen Komponenten / Connection example with various components Speakers Video 1Audio L 1Preampout Car Radio2x Aux-inAmplifier1 1 in 4 3 1 AUX 2CDCin AudioDVD - Player (IVDP-01)Video out AVin Digitalout Audio L out Audio R out CDC-A08IDC-A09CDCout 2 1 Audio R 1 Anschlusskabel/Additional Cables: Video 2Audio L 2 1 RCA-Cable 7 607 885 093 (1,3m) Audio R 2 7 607 886 093 (5m) 234 RCA-Y-Cable 7 607 001 507Video 3Audio L 3 C1-4x Cinch 7 607 893 093 (0,35m) Audio R 3 AUX 2-in 7 607 001 508 Signal Controller IVSC-3302 out D 3 D 2 RightMonitorLeftMonitor IVMS 5802/6502 FrontMonitor Anschlussbild • Connection di...
Otros modelos de este manual:Vídeo del coche - IVMS-6502 (396.78 kb)