Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
bring a complaint to the Commission pursuant to procedures set forth in Subpart E of Part 68, FCC If the LOW BATTERY indicator appears in the display, 3. Release both buttons when the display shows the current contrast level. ALL?. Press the DELETE button once again Thomson Consumer Electronics, Inc. The telephone company may make changes in its communications facilities, equipment, operations of you need to replace the batteries. It is important that to delete all records, or if you don’t wish to 11721 B Alameda Ave. 4. Press either REVIEW or to scroll through the contrast levels. The procedures where such action is required in the operation of its business and not inconsistent with you replace the batteries as soon as possible to delete all records, do not touch any buttons Socorro, Texas 79927 telephone equipment, the telephone company must give you adequate notice, in writing, to allow you to FCC Rules and Regulations. If these changes are expected to affect the use or performance of your levels available are 1-5. guarantee reception of the Caller ID signals. and the unit will timeout after 10 seconds, PM LOW • Pay any charges billed to you by the Exchange Center for service not covered maintain uninterrupted service. 5. Press the DELETE button once to save your selection. keeping the records. by the warranty. • Insure your shipment in case of loss or damage. Thomson accepts no liability INTERFERENCE INFORMATION SUMMARY SCREEN MESSAGE INDICATORS in case of damage or loss. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference The Summary Screen shows the current AM NOTE: Check with your local phone company regarding name service availability. The following special messages indicate the status of a message or the unit: • A new or refurbished unit will be shipped to you prepaid freight. received, including interference that may cause undesired operation. time, current date and number of new calls This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant When you replace the batteries, your Caller ID unit retains stored information for up to 60 What your warranty does notcover: NO CALL The caller memory is empty. to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful seconds. It is still a good idea to write down information that you do not want to lose. to be reviewed. The Summary Screen is interference in a residential installation. • Customer instruction. (Your Owner’s Manual provides information regarding displayed until any button is pressed. After This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in UNKNOWN CALL The incoming call does not have Caller ID service or operating instructions and user controls. For additional information, ask your the new call is received, the Summary accordance with the instructions, may cause harmful interference to radio communications. However, there their service area is not linked to yours. If UNKNOWN dealer.) Screen is displayed after 10 seconds and is no guarantee that interference will not occur in a particular installation. NAME appears with a calling number, the name • Installation and set-up service adjustments. If this equipment does cause harmful interference to radio or television reception, which can be determined by the New Call LED will flash on. information was not available for that number. SERVICE turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the • Batteries. following measures: NOTE: The number of new calls is REPLACE BATTERY Battery power level is low and batteries must be • Damage from misuse or neglect. interference). • Reorient or relocate the receiving antenna (that is, the antenna for radio or television that is “receiving” the FCC requires this product to be serviced only by the manufacturer or its displayed until any new calls have been replaced. reviewed. • Products which have been modified or incorporated into other products. • Reorient or relocate and increase the separation between the telecommunications equipment and receiving authorized service agents. In accordance with FCC requirements, changes or antenna. BLOCKED CALL The caller of the incoming call is registered as • Products purchased or serviced outside the USA. modifications not expressly approved by Thomson Consumer Electronics could • Connect the telecommunications equipment into an outlet on a circuit different from that to which the “Private Number” and their Caller ID information is The time and date will be programmed • Acts of God, such as but not limited to lightning damage. receiving antenna is connected. void the user’s authority to operate this product. For instructions on how to obtain automatically when the fi...
Otros modelos de este manual:Respuestas Automáticas - 2-9022 (98.51 kb)