Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Remove the blue locking clip from the middle of the fibre optic housing. Strain the hook carefully with a sharp tool, while pulling out the optical fibre from the housing. 1b. 1c. Installation Type 1: Vehicles supporting multiple CD changers and equipped with a CD changer • Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7 with MMI-2 High (colour) These vehicles allow selection of Gateway audio sources and the original CD changer through the existing car audio controls. 1 Introduction Gateway 500 emulates a CD changer and uses CD changer controls to access offboard audio sources including iPod, USB devices and Dension Gateway accessories. If your car is not already equipped with a CD changer, it may be necessary to have the car programmed by your dealer in order to use the GW500 with it. Programming the car for GW500 Audi No programming required BMW non iDrive-4 If original CD changer fitted and MP3 capability is available: no programming is required. If original CD changer fitted and no MP3 capability is available: a) Retrofit “KMP3” option with service computer b) Used in non text capable BMW mode If original CD changer not fitted or E60 M-ASK used: install GW500 and retrofit “IPOD” option with service computer BMW with iDrive-4 If original CD changer fitted: no programming is required If original CD changer not fitted: install an original BMW CD changer and retrofit “CD Changer” temporarily option with service computer Mercedes Generally no programming is required but in some cases (e.g. no device was connected onto the optical ring) it is needed to enable a CD changer with the service computer. Porsche Generally it is needed to enable a CD changer with the service computer but in rare cases the PCM accept the GW500 without this enabling process. Saab 9-3 It is needed to enable a CD changer with the service computer using an original CD changer. Installation Type 2a: Vehicles with an existing CD changer These vehicles allow selection of Gateway audio sources and the original CD changer by switching the mode between CD Changer and Gateway mode. Audi (MMI-2 Basic Monochrome) Saab 9-3 (Rear CDC) Porsche (CDR 23/24 and PCM I/II/2.1) for longer CDC and car side cable use FOA1PO1 Mercedes (NTG1-, NTG2- Audio 20/50 and Comand) CDR PCM Text capable BMW E87, E90, E91, E92, E93, E60/61, E63/E64, E65/E66 (03/2005-), E70 and Mini (non iDrive-4) Non text capable BMW E65/E66 (-03/2005) (non iDrive-4) 3 Package Content & Electrical Installation 1 2 3 DIP switch Car side CDC side Power harness 4 Power harness: -red wire (+12V non switched) -black (GND) Car side CDC side BMW E90, E91, E92, E93 with iDrive-4 You must set the mode selector switch to service mode (bypass, CD Changer) position otherwise the service computer may detect an unknown device in the fibre optic system which can lead to errors reported. i Service/CDC mode When servicing your vehicle Text Configuration Saab & Mercedes vehicles require final configuration of the Gateway as not all of the radios in these vehicles support text display. After Gateway 500 has been installed, toggle the mode selector switch six times (three times on/off) and a configuration menu will appear on the radio display. Select the configuration mode according to your head unit listed in the configuration table. To confirm the selection press and hold ; to discard the selection press and hold Track # Config Mercedes Command Saab Text # 1 NO TEXT D D # 2 Timeout - - # 3 Text - - # 4 +Cache - - # 5 +Paging R R # 6 +Select - R For detailed information visit: D: Default, R: Recommended 7 i HU Car side Installation Type 3a: Vehicles with no existing CD changer Set the DIP switches as shown below. Text capable BMW E87, E90, E91, E92, E93, E60/61, E63/E64, E65/E66 (03/2005-), E70 and Mini (non iDrive-4) Audi (MMI-2 Basic Monochrome) Saab 9-3 (Rear CDC) Porsche (CDR 23/24 and PCM I/II/2.1) Mercedes (NTG1-, NTG2- Audio 20/50 and Comand) If you are connecting Gateway 500 to the back of the head unit, use this diagram: CDR PCM Non text capable BMW E65/E66 (-03/2005) (non iDrive-4) Car side Installation Type 3b: If you are installing to a free fibre optic connector in the car (CDC preparation) use this method: 4 5 6 Volvo S40/V50 - MY 2004-2007 with Basic and High Performance sound system, without AUX input, with CDC Installation Type 2b: ICM (Display) Car side LED Volvo XC90 - MY 2002-2006, with High Performance and Premium sound system, without AUX input, with CDC Saab 9-3 (Front CDC) BMW E90, E91, E92, E93 with iDrive-4 Use a CDC for enabling Saab 9-3 (Front CDC) The LED (arrowed) indicates the current operating mode o = GW5 (Blue LED Solid) o = Service/CDC (Blue LED Flashing) LED ...