Votos - 3, Puntuación media: 5
(
)
)
|
Resumen del manual
Note: The amplifier is equipped with a thermal shut off feature. If it overheats, the affected channel will remain off until the temperature falls below the shut off threshold. There are no fuses inside the amplifier. If an overcurrent condition occurs in any channel, an AC line breaker located on the rear panel will trip. To reset, push it back in. 2. CONNECTIONS AND OPERATION continued… A A5 CAUTION 2.4 REAR PANEL LAYOUT 1 – Circuit breaker (two in Statement A5) 2 – Single Ended RCA Input 3 – Trigger Input and Output 4 – Balanced XLR Input 5 – On-Mode (Trigger / Manual / Auto) 6 – Speaker Binding Posts 7 – Power Cord Socket 8 – Chassis Ground 1 2 3 4 5 7 8 STATEMENT A2 STATEMENT A5 6 SPECIFICATIONS Power Output (Continuous RMS, 20 Hz to 20 kHz, <1.0% THD) A2: One Channel Driven (8 .,4 .,2 .) ............................225W,370W,535W All Channels Driven (8 .,4 .,2 .). . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 W, 300 W, 410 W A5: One Channel Driven (8 .,4 .,2 .) ............................225W,370W,535W All Channels Driven (8 .,4 .,2 .). . . . . . . . . . . . . . . . . . . . . . . . . . . . 180 W, 265 W, 340 W* *Special Test Conditions Required for 2 . Frequency Response . . . . . . . . . . . . . . . . . . . . . . . 20 Hz to 20 kHz (+0, -0.15 dB), 5 Hz to 100 kHz (+0, -2 dB) THD+N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.001% at 1 kHz, 0.03% at 20 kHz (200 W into 8 .) IMD ............................................................ 0.0005%(CCIF,225Winto8 .) Power Bandwidth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Hz to 100 kHz (+0, -3 dB, 225 W into 8 .) Slew Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 V/.s Input Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 Vrms in for 225 W out into 8 . Input Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 k. (RCA), 15 k. (XLR) Damping Factor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 360 at 1 kHz (ref. 8 .) S/N Ratio (ref.225W,IEC-Afilter) ......................................................120dB Crosstalk . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -78 dB at 1 kHz Voltage Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 dB XLR Pin Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pin 1: Ground, Pin 2: Positive, Pin 3: Negative POWER REQUIREMENT Power Consumption at maximum power output (8 . load) StatementA2.................................................................800 W Statement A5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1800 W Low voltage version: In countries where the line voltage is 120V, this product operates from a single phase AC power source that supplies between 108V and 132V at a frequency of 60 Hz. High voltage version: In countries where the line voltage is 220, 230, or 240V, this product operates from a single phase AC power source that supplies between 216V and 264V at a frequency of 50 or 60 Hz DIMENSIONS Height . . . . . . . . . . . . . . . . 7 5/8 inches (19.4 cm) including feet, rackmounting – 4 rack units without feet Width StandardVersion..................................................19 1/4inches(49cm) RackmountVersion ................................................19inches(48.3cm) No-HandleVersion...............................................17 1/4inches(43.8cm) Depth .....................................A2:13 1/2inches(34.3cm),A5:19 3/8inches(49.2cm) Weight (unpacked) Statement A2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 lb (15.5 kg) Statement A5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57 lb (25.9 kg) WARRANTY CANADA & USA Anthem Electronics warrants to the original purchaser that each Anthem Statement A Series amplifier is free from defects in workmanship and materials, during normal use, for a period of five (5) years from the date of sale. During the warranty period, Anthem Electronics will repair or replace any defective components free of charge. This warranty is not transferable unless the product is traded-in with an Authorized Anthem Dealer, who may resell the product with the remaining warranty if it is cosmetically acceptable, in perfect working condition, and has not been internally or externally altered. Warranty is void if the Anthem product is not ...
Otros modelos de este manual:Avtousiliteli - STATEMENT A5 (309.59 kb)