Votos - 3, Puntuación media: 3.3 ( )

Fabricar: Lanzar Car Audio Tamaño del archivo: 763.04 kb Nombre del archivo: Idioma del manual:

_ • m ,© wf 40 4k — Mill Max High 40 4k C*1 ®” Input Mode •75 A A LM 40 4k 40 500 Ch4 L _ Y ADAPTOR to OUTPUT fROM HEAD UNIT u Y ADAPTOR to REMOTE SUBWOOFER LEVEL CONTROL TO OUTPUT FROM HEAD UNIT Input Mode Switch in Ch 4 position Ch4 I _ FRONT System Wiring vibe53i 5 CHANNEL BRIDGED MODE CONFIGURATION .X .ÇHANNEL CHANNEL3 + 4 Cl ANN EL 5 + 6 Level Mode .ffET Level Mode Bass Boos {£££ Mode Level .• *M o ff ■In mi— -«■ - ^ Min Max Hlgh40 4k nft Y ADAPTOR RIGHT INPUT jo sooMMMM’“1*1- — ■'» -----lode •WT & A Wp 0 40 4k 40 500 Ch4 1. _ 40 500 Ch4 High _ Band _ U>w to REMOTE SUBWOOFER LEVEL CONTROL to OUTPUT FROM HEAD UNIT System Wiring 5 CHANNEL TRI-MODE CONFIGURATION vibesßi Level Mode Level Mode Bass Boost Mode Level i © .© № P, £9 ,® JP1,• ^ lln Um S>M6 h 40 4k Min Max High40 4k OM J 40 ** Ä A urn [n 40 4k 40 500 Ch4 L 131-II High _ Band. Low Pass Pass Pass Y ADAPTOR to OUTPUT FROM HEAD UNIT Y ADAPTOR to REMOTE SUBWOOFER LEVEL CONTROL TO OUTPUT FROM HEAD UNIT FRONT TO BATTERY ; to REMOTE OUTPUT from HEAD UNIT 16 - jCe anzar Vibe Owner's Manual RIGHT H REAR CH5 ~ Troubleshooting Amplifier will not power up. ■ Check for good ground connection. • Check that remote DC terminal has at least 3v DC. • Check that there is battery power on the + terminal. • Check all fuses. • Check that Protection LED is not lit. If it is lit, shut off amplifier briefly and then repower it. High hiss or engine noise (alternator whine) in speakers. • Disconnect all RCA inputs to the amplifier(s) - if hiss/noise disappears, then plug in the component driving the amplifier and unplug its inputs. If hiss/noise disappears, go on until the faulty/noisy component is found. • It is best to set the amplifier’s input level as low as possible. The best subjective S/N ratio is obtainable this way. Try to drive as high a signal level from the head unit as possible. Protection LED comes on when the amplifier is powered up. • Check for shorts on speaker leads. • Check that the volume control on the head unit is turned down low. • Remove speaker leads, and reset the amplifier. If the Protection LED still comes on, then the amplifier is faulty. Amplifier(s) gets very hot. • Check that the minimum speaker impedance for that model is correct. • Check for speaker shorts. • Check that there is good airflow around the amplifier. In some applications, an external cooling fan may be required. Distorted sound • Check that the Level control(s) is set to match the signal level of the head unit. • Check that all crossover frequencies have been properly set. • Check for shorts on the speaker leads. High squeal noise from speakers. • This is almost always caused by a poorly-grounded RCA patch cord. oCanxar VlBE OWNER’S MANUAL - 17 Lanzar Audio Inc. 1600 63rd Street, Brooklyn, NY 11204 (718) 236-6948 printed in korea...

Descargar ahora

Introduzca dos números de la imagen: