Votos - 3, Puntuación media: 3.3
(
)
)
|
Resumen del manual
We recommend special McCulloch chain lubricating oil. Never use waste oil for this purpose. This results in damage to the bar, the chain and the oil pump. Refill the chain oil tank each time the saw is refuelled. To prevent possible restarting problems avoid running the fuel tank dry. This also helps to extend engine life. NOTE: Saw chain stretches during use particularly when it is new, and it will occasionally be necessary to adjust and tighten it. A new chain will require adjustment after about 5 minutes of operation. The mechanical oil pump for chain lubrication can be adjusted. The feed rate of the chain oil pump can be adjusted by means of the regulating screw (A) (see details in the illustration). ENGLISH - 3 E. Starting and stopping IMPORTANT Never start or operate unless bar and chain are properly installed. Before starting always move the saw away from the fuelling area and place it on a firm, flat surface, the guide bar to the front. STARTING A COLD ENGINE 1 Check that the chain brake is in the disengaged position moving the lever (L) towards the front handle. Move the stop switch upwards . 2 Slide the choke lever (A) to the CLOSED position (OUT). Push the decompression valve (D) down if your models is fitted with one. 3 Depress throttle trigger lock out (S). Depress throttle trigger (G) and then operate throttle advance (P) moving it backwards. 4 Hold the saw firmly as shown in illustration and pull the starter rope until the engine fires once. Beware of moving chain! 5 Move choke lever (A) to the OPEN position (IN). Push the decompression valve (D) down if your models is fitted with one. Pull the starter rope until the engine starts. Allow engine to warm up for ten seconds for better cutting performance. Squeeze the throttle trigger (G) to release the throttle advance. If engine fails to start, repeat these instructions. 6 The engine is stopped by depressing the STOP switch to STOP position. After lengthy use of the chain at full speed,we recommend to run the engine for a few seconds at idle speed before stopping it. STARTING A WARM ENGINE Check that the ignition switch is not in the “stop” position and do not use the throttle lock. Hold the saw firmly, press valve (D) for decompression and pull the starter rope. STARTING A WARM ENGINE AFTER RE-FUELLING In the fuel tank as run completely dry, procede to start as with a cold engine. F. Usage IMPORTANT Before using a chain saw read the Operator’s Manual and all safety precautions carefully. FELLING TREES – Make sure that there are no bystanders or animals in the work area. – Study the direction of the fall of the tree and then plan your exit path away from the planned direction of fall. – Don’t fell trees when there is a strong wind. 1 Clear the tree base of interfering limbs and brush. Clean the work area from stones or other objects which could damage the chain. If the tree has large protruding roots, remove them before felling (see illustrations). 2 A) Cut a felling notch (A) of 45°...
Otros modelos de este manual:Benzo y sierras - P 540E 40 CC (1.96 mb)
Benzo y sierras - 95390011700 (1.96 mb)
Benzo y sierras - Euromac S42 (1.96 mb)
Benzo y sierras - Euromac S43 42 CC (1.96 mb)