Votos - 4, Puntuación media: 5
(
)
)
|
Resumen del manual
Connect the drive to the computer as shown in figure. 1. Connect the USB converter cable to the External Drive. 2. Connect the other end of the USB converter cable to your computer. 3. Connect the AC adapter plug to the power connector at the rear of the drive. Attach the AC adapter to the AC wall outlet. 4. When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Drive and install the software. • Please do not connect the AC adapter and USB 2.0 converter cable by any means other than specified above. Connecting to computer NOTES NOTE To AC wall outlet. Installation Hardware Installation • Make sure you have a personal computer with an open USB port before connecting the drive to your computer. • Power for all device should be turn off before attaching the cables. Connect the drive to the computer as shown in figure. 1. Connect the USB converter cable to the External Drive. 2. Connect the other end of the USB converter cable to your computer. 3. Connect the AC adapter plug to the power connector at the rear of the drive. Attach the AC adapter to the AC wall outlet. 4. When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Drive and install the software. • Please do not connect the AC adapter and USB 2.0 converter cable by any means other than specified above. Connecting to computer NOTES NOTE To AC wall outlet. Removing the USB converter cable The drive supports the plug and play(not swap) function of Windows, and can be removed and inserted by performing the following operation. 1. Stop the application software being currently used. 2. Click the icon “ ” of the taskbar located on your screen’s bottom right side. 3. Click “Safely Remove USB Mass Storage Device-Drive[x:]”. 4. Click “Ok” and then remove the USB converter cable. Don’t remove the USB converter cable when the busy indicator on the drive blinks, or during computer startup. NOTE 7 8 Operation Loading and ejecting a disc Remember - AC adapter must be connected. Make sure the power is turned on. Loading a disc 1. Push the Eject Button to open the Disc tray. 2. Load a disc. (Label facing up.) 3. Close the Disc tray. Ejecting a disc 1. Push the Eject Button to open the Disc tray. 2. Removing the disc. 3. Close the Disc tray after removing the disc. Emergency Eject This drive has a feature that allows the CD to be ejected manually in case of a drive failure or a power outage. NOTE: Don’t use this feature except in an emergency. 1) Turn the power OFF. 2) Poke a fine-tipped object (such as a straightened heavy duty paper clip) into the small hole above the eject button. The front door will pop open and the disk tray will come partway out. 3) Pull the front door to open it all the way, then grip the disc tray between thumb and forefinger and gently pull it straight out. * If you cannot get a good grip on the disc tray with y...
Otros modelos de este manual:Blu-Ray - BE06LU10 (481.27 kb)