Votos - 2, Puntuación media: 3 ( )

Fabricar: LG Tamaño del archivo: 324.95 kb Nombre del archivo: Idioma del manual:

Refer to the manual for the computer for details about removing the cover. NOTE : There may be sharp edges inside the computer so take care to avoid injury. Mounting the Drive 1. Remove the 51/4. drive bay panel from the computer. Refer to the manual for the computer for details. 2. Insert the drive unit into the bay. Do not apply excessive pressure to the cables inside the computer. 3. Secure the drive with the screws. If there is not enough space behind the drive, connect the IDE and other cables before securing the drive. NOTE : This is a general installation guide. If your PC hardware appears different, please consult your hardware manual for installing peripheral devices. Jumper Setup Before installation, set the jumper connector on the rear panel. The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When several (up to four) EIDE devices are connected, each must be set in a unique way. Specific knowledge of hardware and software is necessary to install the drive. R EA D WR I TE R EA D W R IT E 4 NOTE : If two peripheral devices with the same settings are both connected to the Primary or to the Secondary EIDE bus, the host computer may fail to run or may malfunction. Careful attention is necessary. MA: Master SL: Slave CS: Cable Select (CSEL) NOTE : Only one jumper should be installed on the jumper connector. If more than one jumper is installed, the drive may malfunction or be damaged. Master/Slave setting is determined by jumper installation on the Jumper Connector. The following table shows the possible jumper settings. If you use CSEL setting, the MASTER/SLAVE setting will be made automatically, depending on the hardware configuration. For more details refer to the manual of your computer. PC Connection The Super Multi DVD Rewriter connects to the motherboard of the host computer using an IDE interface cable. You may connect the Super Multi DVD Rewriter as a Slave or Master device, depending on your computer. To Install as a Master Drive To install the drive as a Master, the jumper can be left as supplied from the factory. NOTE : A hard disk is normally installed as the Primary Master on the EIDE (ATAPI) interface. Other EIDE peripheral devices such as hard drives and Super Multi DVD Rewriters are then set differently. 5 Name Function Drive set as Master Drive set as Slave MA (Master) SL (Slave) CS (Cable Select) C S S L M A Drive mode set by CSEL on the host IDE interface Primary connector Secondary connector Master drive (Super Multi DVD Rewriter) (Jumper left as Master) Motherboard - OR - DIGITALANALOG INTERFACEPOWER DRCSM SLA GLG39 1 +5+12GND 40 2 AUDIOAUDIO Master drive (Booting hard disk) Secondary connector Master drive (Super Multi DVD Rewriter) (Jumper left as Master) Slave drive (Other IDE drive) DIGITAL ANALOG INTERFACEPOWER D RCSM SLA GLG 39 1 +5+12GND 40 2 AUDIOAUDIO DIGITALANALOG INTERFACEPOWER DRCSM SLA GLG 39 1 +5+12GND 40 2 AUDIOAUDIO Master drive (Booting hard disk) Primary connector To Instal...

Descargar ahora

Introduzca dos números de la imagen: