Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
onto a disc. 1 * Do not expose the discs to direct sunlight or excessive heat. * Clean the discs before inserting them into the disc magazine. Always clean a disc from center outward with a cleaning cloth. * Never use solvents such as benzine or alcohol to clean a disc. * You cannot play an 8cm(3 inch) CD even with the specially designed adapter. Notes on the disc magazine * Do not leave the disc magazine in a place subject to excessive temperature or humidity. * Do not insert more than one disc per slot. * Do not drop the disc magazine. 2 1. * Pull out the slot by pulling the part o with finger. * With the label side up, insert a CD all the way Label side 6 discs, one in each slot * Push slot and close it. 2. 3. Insert the magazine firmly (which has been taken out of the unit) with the ^ mark visible on the top side. To remove * Press the eject button and pull out the disc magazine. 4. SLIDE CLOSE 3 ( * • (..'/Vj'l'A I, f, A't1 f Oil Supplied mounting kit ® BRACKET X 2 © Double-sided tape X 1 © TAPPING SCREW X 4 @ Adhesive label X 1 t © WASHER SCREW X 4 © PLATE BRACKET © BOLT X 4 © NUT X 4 w • Precautions Select the mounting location very carefully by referring to the following points * Make sure that there is not a fuel tank, wiring or piping on the other side of the mounting surface. * Make sure that the installation of the unit will not hinder the movement of the trunk lid or interfere with the spare tire etc. * Use only the supplied mounting kit for a safe and proper installation. Removing the transport screws Find the 3 transport screws at the bottom of the unit, which lock the unit’s mechanism during transport. Remove these screws before installation and attach the supplied adhesive labels © over the holes. Retain these screws and replace them in the original positions if the unit is transported for service or maintenance. Installing the unit Mounting angle setting lever Be sure to adjust Mounting Angle Setting Lever(A) to appropriate angle; 0°or horizontal, 22.5° angle, 45° angle, 67.5 angle, 80° angle, or 90° for vertical. Direction change lever (A) 0° HORIZONTALLY 45° (angled mounting) 90° □ VERTICALLY 5 After adjustment, be sure to attach the Double side Tape . Note Do the same procedure on the other side of the unit. Horizontal installation Construction Making holes on the carpet Completion About parts numbers 0@ ©@©©,refer to page 4. angled installation Be sure to turn the mounting angle setting dial to the 45° position. 6 Vertical installation 1. Construction 3. Making holes on the carpet 2. Removing temporarily 4. Completion About parts numbers O0© ©O©, refer to page 4. Suspended installation When installing the unit in the trunk under the rear window shelf, observe the following. - Make sure that the unit is suspended horizontally. - Select the mounting location carefully so that the unit does not hinder the movement of the torsion bars of the trunk lid. - Make sure that there is nothing on the other side of the mounting location before drilling the holes. - Select the correct size screw to avoid damaging the vehicle rear deck. 1. Construction 2. Making holes 3. Completion Note About parts numbers O@0, refer to page 4. 8 When connecting, run the supplied connecting cable and connect to Audiovox model PAV-9 as illustrated here. Caution Make sure to disconnect the ground wire terminal of the car battery before making a connection in order to prevent short circuiting. PAV-9 Note Use only the supplied connecting cable. For complete operation instructions, refer to pages 18,19 and 20 in the PAV-9 owner's manual.