Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
• Repeat this procedure to tighten the other belt. To loosen the belts: • Feed the free end of the belt up through the buckle to form a loop A . Enlarge the loop by pulling on the end of the loop toward the buckle. • Pull the anchored end of the belt to shorten the free end of the belt B . • Repeat this procedure to loosen the other belt. Note: After adjusting the belts to fit your child, make sure you pull on them to be sure they are securely fastened. Free End Anchored End Buckle TIGHTEN Free End Anchored End Buckle LOOSEN 1 3 2 7 Setup and Use To prevent serious injury or death: • Fall Hazard – It is dangerous to use this reclined cradle on an elevated surface, since child’s movement may cause product to slide or tip over. Use only on a floor. • Suffocation Hazard – Never use on a soft surface (bed, sofa, cushion), since product can tip over and cause suffocation in soft surfaces. • Always use the restraint system. • Never leave child unattended. • Never use as a car seat. • Never use as a carrier or lift while child is seated. Never use the toy bar as a handle. • Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg/ 20 lbs). WARNING Restraint Belt Securing your Child • If the toy bar is attached, remove it before placing your child in the seat. Place your child in the seat. Position the restraint pad between your child’s legs. • Fasten both restraint belts to the buckles on each side of the restraint pad. Make sure you hear a “click” on both sides. • Check to be sure the restraint is securely attached by pulling it away from your child.The restraint should remain attached. • Attach the toy bar, if desired (see Assembly step 7). Restraint Pad Buckle Calming Vibrations • Make sure your child is properly secured in the seat. • To turn vibrations on, slide the power switch on the soothing unit to the on position . • To turn vibrations off, slide the power switch on the soothing unit to the off position . IMPORTANT! If vibrations become faint, or if there are no vibrations, remove the “D” (LR20) batteries from the soothing unit and dispose of them properly. Replace the batteries with four, new “D” (LR20) alkaline batteries. To tighten the belts: • Feed the anchored end of the belt up through the buckle to form a loop A . • Pull the free end of the belt B . • Repeat this procedure to tighten the other belt. To loosen the belts: • Feed the free end of the belt up through the buckle to form a loop A . Enlarge the loop by pulling on the end of the loop toward the buckle. • Pull the anchored end of the belt to shorten the free end of the belt B . • Repeat this procedure to loosen the other belt. Note: After adjusting the belts to fit your child, make sure you pull on them to be sure they are securely fastened. Free End Anchored End Buckle TIGHTEN Free End Anchored End Buckle LOOSEN 1 3 2 7 4 Rainforest Sounds or Music • Slide the switch to rainforest sounds or music . Child-activated (Short Play) • Slide the mode switch to for child activated mode. • When baby bats the monkey or the toucan, baby is rewarded with rainforest sounds or music along with motion and lights. Parent-activated (Long Play) • Slide the mode switch to for parent activated mode. Baby enjoys 10 minutes of rainforest sounds or music, a light show and motion. Off • Slide the mode switch to to turn off sounds, lights, and motion. Volume • Push the volume button once for low volume ; press again for high volume ; press again for off . IMPORTANT! If lights dim or sound or movement become faint or stop all together, remove the "D" (LR20) batteries from the soothing unit and dispose of them properly. Replace the batteries with four, new "D" (LR20) alkaline batteries. Mode Switch Volume Button Rainforest Sounds or Music Switch Setup and Use Remove the Toy Bar • Pull the ends of the latches and lift the toy bar. Latch 5 Care The pad is machine washable.Wash the pad separately in cold water on the gentle cycle. Do not use bleach.Tumble dry separately on low heat and remove promptly.The frame, toy bar can be wiped clean using a mild cleaning solution and damp cloth. Do not use bleach. Do not immerse the soothing unit or toy bar. 8 ©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A. K2566b-0726 4 Rainforest Sounds or Music • Slide the switch to rainforest sounds or music . Child-activated (Short Play) • Slide the mode switch to for child activated mode. • When baby bats the monkey or the toucan, baby is rewarded with rainforest sounds or music along with motion and lights. Parent-activated (Long Play) • Slide the mode switch to for parent activated mode. Baby enjoys 10 minutes of rainforest sounds or music, a light show and motion. Off • Slide the mode switch to to turn off sounds, lights, and motion. Volume • Push the volume button once for low volume ; press again for high v...