Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
Child Tray Figure 5. Solid Cap Locking Cap Rear Wheels Stroller Figure 1. Base Car Figure 2. Rear Axle Assembly Hub Cap Front Wheels 3 Figure 4. Parent Tray * To attach the front child tray, push the angled tray onto the post at the end of the right armrest, while pressing downward on the snap button, until locked into place. Please see figure 7. Rotate the tray downward until latched onto the left armrest. Please check that the snap button comes through and securely latches the tray in place. Please see figure 8. * To remove front child tray, press inward on the left side tray release button and rotate upward on the tray. Please see figure 9. Please note that you may remove the tray completely by depressing the snap button on the right side as shown in figure 10 while pulling forward on the tray. Please see figure 7. * To install the canopy slide the male ends of the canopy into the female slots on the stroller frame. Please see figure 11. To open the canopy push forward on the front frame tube of the canopy. Please see figure 12. * The stroller handle has multiple positions. To adjust the handle to your desired position, press in both round buttons at each end of the handle. Please see figure 13. * To attach the parent tray line up the parent tray slots with the corresponding slots on the stroller frame, slide down until it locks into place. Check to make sure the parent tray is secure before using. Please see figure 14 * To remove the parent tray, locate the locking tabs under the tray, pull outward on the locking tabs and lift up to remove. Please see figure 15 4 Figure 9. Figure 7. Figure 8. Figure 12. Front frame tube Figure 10. Figure 13. Figure 11. Figure 14. Figure 15. TO SECURE THE CHILD • The shoulder straps of the 5-point harness have 3 attachment positions. Select the position that places the shoulder strap level with, or below the top of the child's shoulder. To access the harness pull apart seat pad. Please see figure 16. • Carefully place the child in the stroller seat and bring the safety harness around the child's waist and over the shoulders. Place the crotch strap between the child's legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child's waist and over the child's shoulders Please see figure 17. Figure 16. ShoulderStrapSqueezeCrotchStrapWaistStrapAdjustforasnugfit Figure 18. Figure 17. • To release, apply pressure to both sides of each male clip until the clip is released. See figure 18. This process requires a moderate amount of effort so as to prevent an accidental release by your child. WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness. STRANGULATION HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone. 5 6 ATTACHMENT OF THE BABY TREND INFANT CAR SEAT * To attach the Baby Trend Infant Car Seat, recline the seat all the way back. Please see figure 19 * Check that the front child tray is firmly attached to the stroller armrests. Make sure that the car seat locks into the front child tray. Then turn tabs on stroller frame to lock the front of the car seat into the stroller. See figure 20. * Position the Infant Car Seat, facing toward the rear of the stroller, so that the seat shell goes into the front tray and latches into place. Please see figure 21. Check that the Infant Car Seat is firmly locked onto the front tray before using. * To remove the Infant Car Seat, squeeze the release handle located at the foot-end of the seat and carefully lift upward on the seat. Please see figure 23. Figure 20. Figure 22. Locks into tray Figure 21. WARNING: Failure to follow these car seat attachment instructions could result in serious injury or death. Figure 19. SEAT BACK POSITIONING WARNING: The upright position should be used only for a child that is at least 6 months old. * The seat has a multiple position recline that is controlled by a cord and spring loaded adjuster behind the seat. To recline the seat, pull back on the loop of the adjuster. Please see figure 23. To place the seat back in a more upright position, grab the adjuster with one hand and pull the cord to the desired position with the other hand. See figure 24. The cord will lock automatically. Figure 24. Figure 23. BRAKES WARNING: Always set brakes when the stroller is not being pushed so that the stroller will not roll away. Never leave stroller unattended on a hill or incline as the stroller may slide down the hill. * To engage brakes, apply light downward pressure to the brake lever located on each rear wheel. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster. See figure 25. Check that the stroller will not move and that the brakes are properly applied. To release, gently lift up on the brake lever. Figure 25. 7 CANOPY * To open the canopy, push forward on the front frame of th...