Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
Mark pole sections with tape (not supplied) at indicated distances from ends as shown. Tape (Not Supplied) 18" (42.7 cm) 6" (15.2 cm) 24" (61 cm) PLAYING SURFACE GROUND SURFACE 2. Ensure ground is level with playing surface, then dig pole hole. CONTACT UTILITIES BEFORE DIGGING. WARNING! IMPORTANT!: Maximum distance from edge of hole to edge of playing surface 6” (15.2 cm). 9 10/04 P/N 21168202 4. 1" (2.54 cm) SIDE VIEW Fill hole approximately 1/3 full with mixed concrete. FIG. A FLANGE Insert ground sleeve assembly and center in hole (FIG. A). Note: Leave 1" below flange exposed for drainage hill. 5. IMPORTANT!: NOTE POSITION OF FLANGE IMPORTANT!: CONTINUE ON TO NEXT STEP. DO NOT WAIT FOR CONCRETE TO CURE. PLAYING SURFACE 3. Snap two halves of ground sleeve (4) together. Insert and secure bottom pole section (3) into ground sleeve (4) by tightening ground sleeve cap (5). NOTE: Flared end goes inside ground sleeve. 3 5 4 4 P/N 21168202 10/04 10 4 3 Fill hole completely with concrete. 6. 1" (2.54 cm) 5 1" (2.54 cm) 7. Tamp down concrete to release air pockets and build drainage hill. Level pole section in all directions several times while concrete is curing. 1" (2.54 cm) SIDE VIEW DRAINAGE HILL IMPORTANT!: CONTINUE ON TO NEXT STEP. DO NOT WAIT FOR CONCRETE TO CURE. IMPORTANT!: WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO NEXT STEP. CONCRETE MUST CURE. PLAYING SURFACE Make a reference mark here for anti-skid tape. NOTE A: Keep flange pushed down to concrete and leveled. NOTE B: After concrete has cured, remove bottom pole section from ground sleeve (4). Place anti-skid tape (36) around the bottom area of bottom pole (see note A). KEEP GROUND SLEEVE CAP ON BOTTOM POLE. 36 4 8. 5 36 4 8. 5 NOTE A: Place top edge of anti-skid tape on mark made in step 7. NOTE B: Tape prevents the pole from rotating during play. 11 10/04 P/N 21168202 P/N 21168202 10/04 12 1 5 9. Stack and bounce bottom (3) and middle (2) pole sections together. Bounce pole sections together until middle section no longer moves toward taped reference mark on bottom pole. 2 IMPORTANT 5 Keep on Bottom Pole 3 Wood Scrap (NOT SUPPLIED) 10. Stack upper pole section (1) to bottom and middle pole assembly and continue bouncing until top pole (1) no longer moves toward taped reference mark on middle pole. IMPORTANT!: POLE SECTIONS SHOULD HAVE A 3-1/2" (9 CM) MINIMUM OVERLAP. Wood Scrap (NOT SUPPLIED) Taped reference marks 1-1/2" (3.81 cm) Tape 5" (12.7 cm) Tape 1-1/2" (3.81 cm) Tape 5" (12.7 cm) Tape IMPORTANT!: WARNING FAILURE TO FOLLOW THESEWARNINGS MAY RESULT INSERIOUS INJURYAND/ORPROPERTYDAMAGE. Owner mustensure that all players knowandfollow these rules for safe operation of the system. •DO NOTHANG ontherimorany partof the system including backboard,support braces or net. •Duringplay, especially when performingdunk type activities,keep player's face awayfromthebackboard, rim andnet.Serious injury could occur if teeth/face comein contactwith backboard, rimornet. •Donot slide, climb, shake orplayon base and/or pole. •After assembly is complete, fill systemcompletelywith water or sand and stake to the ground.Never leave system inan upright positionwithout fillingbasewith weight,as system may tip over causinginjuries. •When adjusting heightor moving system, keep hands and fingers away from moving parts. •Do not allow children tomove or adjust system. •Duringplay, do notwear jewelry (rings,watches,necklaces, etc.).Objects may entanglein net. •Surfacebeneaththe basemust be smooth and free of gravel orothersharpobjects.Puncturescause leakage and couldcause systemto tip over. •Keeporganic material awayfrom pole base.Grass,litter, etc.could cause corrosion and/ordeterioration. •Check polesystem forsigns ofcorrosion (rust,pitting, chipping)and repaintwith exterior enamel paint.If rust has penetrated through the steel anywhere,replace pole immediately. •Check system before each useforproperballast,loose hardware,excessive wearand signscorrosion and repair before use. •Check systembefore each use forinstability. •Do not usesystem duringwindyand/or severe weather conditions;system may tipover.Place system in the storage position and/or in an areaprotected from thewind and freefrompersonal property and/oroverhead wires. •Neverplayon damagedequipment. •See instruction manual forproperinstallation and maintenance. •When movingsystem, use cautionto keep mechanism from shifting. •Keeppole topcovered withcap at all times. •Do not allow water intank to freeze. During sub-freezing weatheraddnon-toxic antifreeze,sandor emptytank completely and store. (Donot use salt.) •Useextreme cautionifplacing system on slopedsurface. System may tip over moreeasily. 2012412/99 IntheU.S.:1-800-558-5234 and Canada:1-800-284-8339 The warning label should be 90 degees from uppermost holes on top pole (1) - see Illustration. 11. Install pole mount bracket (6) and bracket reinforcement (40) with carriage bolts (7) as shown. Tighten flange nuts (8) completely. 11. Install pole mount bracket ...