Votos - 4, Puntuación media: 4
(
)
)
|
Resumen del manual
For infant car seat.s instructions, please refer to the manual located under the car seat MODEL # 1956CT Serengetti ™ Travel System Instruction Manual Convenience through Innovation and thoughtful design Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved. WARNINGS * Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition. * The maximum weight that can be carried in the storage basket is 5 lbs. The maximum weight that can be carried in the Parent Tray is 3 lbs. Excessive weight may cause a hazardous unstable condition to exist. * Be certain the stroller is completly opened and locked in place before allowing a child near the stroller. * The maximum weight capacity of this stroller is up to 45 pounds additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist. * use the stroller on stairways or escalators. * Never allow your stroller to be used as a toy. * To clean use only mild household soap or detergent and warm water on a sponge or clean cloth. * Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed. * Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service department to arrange for repair or obtain replacement parts. Please: If you experience any difficulty with the use of our product or have a question regarding these instructions, please contact our Customer Service Department at (800) 328-7363 between the hours of 8:00 am and 4:30 pm Pacific Standard Time or visit us online at Please do not return to the store as once it is returned it cannot be resold and the materials and energy used to make it are wasted. To Contact Us: Baby Trend, Inc. Customer Service Hot Line 1567 S. Campus Ave. (800) 328-7363 Ontario, CA 91761 8:00 a.m. to 4:30 p.m. Pacific Standard Time Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved. PARTS Child Tray Locking Washer (2) Rear Wheel (2) Flex-Loc Base Hub Cap (2)Parent Tray Car Seat Stroller Rear Axle Assembly Front Wheel (2) Solid Cap (2) TO ASSEMBLE STROLLER TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. 1. Carefully remove stroller from the carton. Note: Front wheels, rear wheels, child tray and parent tray MUST be installed before using. 2. Unfold stroller frame by sliding the RED thumb trigger to the left and squeezing the RED pull trigger while pulling backward on the stroller handle. (Fig. 1-2) 3. To attach the front wheels, lean the stroller back so that it rests on the handle with the front and rear legs pointing upward. Position the front wheels over the front leg tubes so that the hole in the housing lines up and will slide onto the legs. (Fig. 3) Firmly push down until the wheels lock securely into place. Tug on each wheel to ensure they are both securely attached. 4. Attach the rear axle assembly and wheels as follows: a. Position axle assembly over the rear leg tubes, brake pedals facing the back. At the same time, push down applying equal pressure to both sides until they lock into place. (Fig. 4) b. Slide a wheel onto each side of the axle. (Fig. 5) c. Secure both wheels using with a locking washer. Push locking washer firmly in place. (Fig. 6a) d. Cap axle end using the solid metal caps. (Fig. 6b) e. Cover and finish using hubcaps. (Fig. 6c) Pull on both wheels to ensure they are secure and can spin freely. Note: DO NOT use stroller if wheels do not lock into place. If you need assistance, please contact our customer service department at (800) 328-7363, M-F, between 8am and 4:30pm, PST. Fig. 3 Fig. 1 Fig. 2 3 Fig. 4 Fig. 5 c b a Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved. 5. To attach the child tray; push the angled side of the tray onto the post at the end of the right armrest while pressing downward on the snap button, until locking in place. (Fig. 7) Rotate the tray downward until it latches onto the left armrest into place. (Fig.8) Note: Check that the snap button comes through and securely in place. (Fig. 9) You can remove the tray completely by pressing the snap button on the right side and pulling forward on the tray until released. (Fig.10) 6. To install the canopy, slide the male ends of the canopy into the female slots on the stroller frame. (Fig.11) Open canopy, by pushing forward on the front frame of the canopy. Close canopy by pulling backwards. (Fig.12) 7. To attach parent tray, line up the parent tray slots with corresponding slots on the stroller frame and slide down until locking into place. (Fig. 13) Check to make sure the parent tray is secure before using. Fig. 7 Fig. 8 Front frame tubeFig. 9 Fig. 10 Fig. 12 Fig. 13 Fig. 11 Fig. 14 Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved. 4 TO SECURE THE CHILD • Th...