Votos - 4, Puntuación media: 4
(
)
)
|
Resumen del manual
• Accessories which are not approved by the manufacturer or distributor should not be used. • WARNING: Prevent serious injury to your child by always using the safety harness. • WARNING: Any load attached to the handle affects the stability of the stroller. • WARNING: It may be dangerous to leave child unattended. • Always use your wrist strap – these strollers can really roll, and the wrist strap gives you control if you should slip or fall down. • The passenger should remain seated (no standing in the stroller). • Watch out for cars – never assume that a driver can see you and your child. • Never use Roller Blades while using a Baby Jogger Stroller. • Intended for passengers up to five years of age weighing no more than 150 pounds. • This Jogger seats two passengers. • WARNING: Recommended weight for seat pocket is 2 pounds and basket is 10 pounds. Excessive weight may cause a hazardous unstable condition to exist. • It may be unsafe to use replacement parts other than those supplied or approved by the manufacturer. For the sake of your precious these warnings before using Performance Double (12/16/04 4:08 PM Page 2 REMOVE ALL PROTECTIVE CAPS THE PLASTIC FORKTIP PROTECTOR Canopy Forktips Plastic Protector 1 Thread the center canopy connection through the seat to secure to the frame using a phillips head screwdriver, attach canopy to frame on all three Frame connections. (Assistance may be helpful to hold in position while attaching screws) Jawslide Camlock • Slide side braces located under seat into Jawslides by pulling up on Camlock and securing into place. 2 Snap canopy strap to frame 3 Velcro canopy straps to 4 Secure center sun canopy on each side. back of sun canopy. velcro strap around the center bar of jogger frame. 23 • To install, gently slide the wheel’s axle into the hole in the axle end until you hear it click into place. the spring lock while 5 Close caliper by flipping pulling out the wheel. the caliper lever toward the fork tips. emove, simply push in Wheel Lever SpringLockSpring Lock Performance Double (12/16/04 4:08 PM Page 4 45 Performance Double (12/16/04 4:08 PM Page 6 Safety Harness Adjusting safety harness: • Slide the end of the shoulder strap back into plastic guide. Please note: If you feel the straps are too tight, you may adjust their length by sliding the plastic guides toward the top of the seat. • Loosen the shoulder straps from their plastic guides. • Lock both sides of the strap mechanism into the center buckle. To adjust the center strap, • Slide the end of each strap through pair of seat loops closest to your child’s shoulder. move its plastic guide up or down. WARNING: Avoid serious injury from falling or sliding out. Always use safety harness! 67 Performance Double (12/16/04 4:08 PM Page 8 Brakes Hand Brake with Parking Button • To use the parking button feature, simply squeeze the brake handle and push the park brake button. • Rotate hand brake assembly upward to a comfortable position then tighten bolt (clockwise) on the hand brake assembly with supplied allen wrench as shown. Rear Wheel Parking Brakes • Simply push brake pedal down to engage brake and lift up to release. Brake Pedal Seat 1 Snap seat to frame. 2 Attach bottom part of seat to footplate with the velcro. NOTE: Some Joggers are shipped with the Canopy, Seat and Basket pre-assembled. Assembly instructions are given if any pre-assemble items are removed for cleaning or replacement. 3 Wrap bottom straps around frame, thread strap through D-ring and secure. 4 Snap center anchor strap. 5 Attach seat anchor straps to rear frame uprights. JOGGER IS PACKAGED WITH THE HAND BRAKE ASSEMBLY LOOSE. TIGHTENING IS NECESSARY FOR SAFE OPERATION! Adjusting the Brake Small RingCylinder Ring Parking Button • If you don’t have good braking action, simply squeeze the brake handle five or six times. If the problem persists, loosen the brake’s cylinder ring to adjust the small ring, and then move the small ring away from the handle to tighten the cable. (Please do not over tighten!) To lock the rings, tighten the cylinder ring against the handle while holding the small ring in place. Performance Double (12/16/04 4:08 PM Page 10 Basket Reclining Seat 1 Simply adjust seat straps 2 Pull on strap when you 3 Rear flap serves as sun to desired degree of want to return the seat canopy when seat is in recline. to its upright position. reclined position. 1 Snap front basket straps to seat’s 2 Snap the rear snap strap around upright. bottom straps. Note: The rear of basket has the mesh material and the front doesn’t. 4 Jogger is packaged with seat support board and can be easily removed or inserted into the seat back if additional support is desired. Be sure to remove the board from the back of the seat before washing. 10 11 Performance Double (12/16/04 4:08 PM Page 12 In Motion Steering • Steering your stroller is simple: it’s balanced to turn with just a light touch on the handlebar. For tighter turns, push down on the handlebar and rai...