Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
The cooler area will be in the middle section. The upper part of the cabinet is the warmest section. When the temperature is adjusted, allow 24 hours for the unit to stabilize. To set the control, turn it to the midpoint setting (approximately 45.F). Once the beverage center is loaded, allow at least 24 hours before making any adjustments to the initial setting. Interior light The interior light makes it easy to view your beverage labels and enhances the and switch display of your collection. When the switch is in the OFF position, the light comes on only when the door is opened. When the switch is in the ON position, the light remains on continuously for your maximum viewing pleasure. For best viewing, do not store a bottle on the top shelf directly under the light. Remember to turn off the light when it is no longer needed. Glass shelves Tempered glass shelves in the beverage center unit are removable for easy cleaning or for storing larger items. To remove a shelf, open the door completely to avoid potential damage to the gasket. Lift up on the back of the shelf slightly. Tilt the shelf to one side at an angle while pulling forward. To replace a shelf, open the door completely to avoid potential damage to the gasket. Tilt the shelf to one side at an angle and slide toward the back wall, placing one side onto the shelf support. Place the other side onto the opposite shelf support. Ensure rear locking tabs are engaged. When installed properly, the shelf will not slide forward when gently pulled. 8 To remove, lift up on the back of the shelf Tilt the shelf at an angle while removing Place in slots when replacing the shelf or replacing Controls and Features Beverage Center Loading tips and suggestions Removing full extension drawers The bottom two full extension drawers hold six bottles each and are loaded with necks facing the rear. Tall bottles should not be loaded on the bottom drawer because they may prevent the door from closing. Do not allow children to climb, stand or hang on the beverage center shelves or full extension drawers. They could seriously injure themselves and possibly cause damage to the beverage center. NOTE: This unit is for storing beverages only and not intended for the storage of perishable foods. The bottom full extension drawers pull out so bottles can conveniently be added or removed. The upper full extension slide can be removed for magnums or larger bottles. To remove: 1. Pull the full extension drawer out to the STOP position. 2. Push the tab on right drawer guide down while pulling the tab on left guide up, and pull the drawer out. To replace: 1. Push the drawer slide arm back into the unit. 2. Pull the small slide sub assembly completely forward. 3. Insert the sides of the drawer back into the guides. 4. Push until the tabs lock into place. Bottom drawer arrangement Tab (push tab down on right drawer guide, pull tab up on left drawer guide) To replace, push drawer slide Pull small slide sub assembly arm back into unit completely forward NOTE: Make sure the tabs on the full extension drawer guides are fully engaged before loading any bottles. Pull the drawers out all the way to the STOP position and push back in several times to make sure locking tabs are properly engaged. Wood drawer fronts The full extension drawer fronts on the beverage center are unfinished cherry wood. During use, oil from hands may accumulate and stain the wood. • The drawer fronts may be stained and sealed to match adjacent cabinetry. The tinted glass will make the stained wood appear darker. A true color match can be seen only when the door is opened. • Apply the stain and sealer according to the manufacturer’s instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product. NOTE: Natural wood may vary slightly in grain and color. Care and Cleaning Beverage Center Unplug the beverage center before cleaning. Cabinet The exterior surfaces can be washed with mild soap and water. Rinse thoroughly with clear water. Never use abrasive scouring powders. Glass door Use a glass cleaner or mild soap and water and a soft cloth to clean the glass door. Do not use any abrasive powders. Door gasket The vinyl gasket may be cleaned with mild soap and water, a baking soda solution or a mild scouring powder. Rinse well. After cleaning the door gasket, apply a thin layer of paraffin wax or petroleum jelly to the door gasket at the hinge side. This helps keep the gasket from sticking and bending out of shape. Light bulb replacement Unplug the beverage center before replacing the light bulb. To remove the light shield, push in the tab on the left side of the shield and lower it. Replace with a 15 watt appliance bulb. In the event of a power failure If the power fails, open the door as infrequently as possible to maintain the temperature. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other applia...