Votos - , Puntuación media:
(
)
)
Fabricar: Coleman
Tamaño del archivo: 173.29 kb
Nombre del archivo: 99c7b10d-d89f-499a-955b-aa9a5d7b3868.pdf
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Once adapter is in place and water is turned on at the source, use Hot Water on Demand™ to turn water on & off and to select desired water temperature. » o» WATER HOSE ADAPTER Parts Identifier Water Tubing Adapter Water Inlet Fitting Quick Connector Be sure Hot Water on Demand™ is turned off and no water is running through unit. Operate unit from a camp table or picnic table. Do not set it on ground to use. (Water will drain when unit is off, preventing damage in freezing temperatures. Attach Water Hose Adapter to Hot Water on Demand™: Remove water pump assembly: a. Disconnect water pump electrical connection from Hot Water on Demand™ (fig. 1). b. Remove water pump by releasing | | the quick connector (fig. 1). Attach Water Hose Adapter to Hot Water on DemancTVntinued): 2. Connect Water Hose Adapter to Hot Water on Demand™: a. Connect Water Hose Adapter electrical connection to Hot Water on Demand™. b. Connect Water Hose Adapter to Hot Water on Demand™ by inserting Quick Connector. c. Connect and tighten water hose to adapter water inlet fitting. d. Connect water hose to water source. To Start Hot Water on Demand™: 1. Turn on water at source (fig. 2). 2. Turn Hot Water on Demand™ Control Knob to “COOL” until water dispenses (fig. 3). 3. Turn Control Knob to “OFF” (fig. 4). 4. To select desired temperature setting, turn Control Knob, counterclockwise. To Start Hot Water on DemancTVntmued): To Remove from Hot Water on Demand™: 1. Disconnect Water Hose Adapter electrical connection from Hot Water on Demand™ . 2. Disconnect adapter hose from Hot Water on Demand™ by releasing the Quick Connector. 3. Reconnect Water Pump electrical connection to Hot Water on Demand™ . 4. Reconnect Water Pump hose to Hot Water on Demand™ by inserting the Quick Connector. Maintenance: To Clean: 1. In a clean container mix one-gallon of water with 6 oz. of a calcium, lime, and rust remover solution (available at hardware, general merchandise and food stores). 2. Disconnect water hose adapter from unit. 3. Unscrew water tubing from adapter body. 4. Detach clips from water tubing. 5. Submerge water tubing in cleaning solution. Allow to set five (5) minutes. 6. Run clean water through water tubing. 7. Air dry. 8. Reattach tubing to Water Hose Adapter and reattach clips to water tubing. For information regarding other Hot Water on Demand™ accessories: Visit us at The Coleman Co., Inc. • 3600 N. Hydraulic • Wichita, KS 67219 U.S.A. 1-800-835-3278 • TDD: 316-832-8707 ©2003 The Coleman Company, Inc. All Rights reserved. Coleman® is a registered trademark of The Coleman Company, Inc. 2300-052 (05/03)...