Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Cine en casa - HT-Z110 (3.68 mb)
Cine en casa - HT-Z110 (4.71 mb)
Cine en casa - HT-Z110 (4.11 mb)
Resumen del manual
to a station. Press and hold TUNING( , ) to automatically search for active broadcasting stations. Briefly press TUNING( , ) to increase or decrease the frequency incrementally. Main Unit 1Press the FUNC- TION button to select the FM band. 5 5 4 4 2 2 6 6 To preset another Press Press the TUNER Select a broadcast station, repeat steps to select preset MEMORY button station. 2 to 5. number. again. Automatic Tuning 1 Press the STOP ( ) • You can select between 1 and button to select 15 presels. PRESET and then press button to select the preset station. RADIO OPERATION Automatic Tuning 2 Press the STOP ( ) button to select "MANUAL" and then press and hold button to automatically search the band. Manual Tuning Press STOP ( ) to select MANUAL and then briefly to tune in to a lower or Note press higher frequency. • This unit does not receive AM broadcasts. 56 To tune in to a preset station, press on the remote control to select a channel. 55 • Each time the button is pressed, the sound switches between "STEREO" and "MONO". • In a poor reception area, select MONO for a clear, interference-free broadcast. Press MO/ST button to listen in Mono/Stereo. (This applies only when listening to an FM station.) GB Convenient Sleep Timer Function You can set the time that the Home Theater will shut itself off. Press SLEEP button. • "SLEEP" will be displayed. Each time the button is pressed, time changes as follows: 10 . 20 . 30 . 60 . 90 . 120 . 150 . OFF. To confirm the sleep timer setting, press SLEEP button. • The remaining time before the Home Theater will shut itself off is displayed. • Pressing the button again changes the sleep time from what you have set earlier. To cancel the sleep timer, press SLEEP button until OFF appears on the display. Mute Function This is useful when answering a doorbell or telephone call. Press MUTE button. Connecting 2 2 1 1 Turn the MIC VOL to Connect the micro- adjust the voice vol phone to the MIC jack ume of the micro on the front panel. phone. • You can connect up to two microphones. 3 3 Turn the ECHO LEVEL to adjust the echo level of the microphone. • ‘ MUTE ON’ appears in the display. • To restore the sound, press the button again to select ‘ MUTE OFF’. MISCELLANEOUS GB Before Refer to the chart If the problem if the instruction below the unit, disconnect dealer or Samsung Electronics Symptom Check/Remedy Symptom Check/Remedy Disc tray does not open. • Is the power cord plugged securely into the • Turn off the power and then turn it back on. Playback does not start. • Check the region number of the DVD. DVD discs purchased from abroad may not be playable. • CD-ROMs and DVD-ROMs cannot be played on this Home Theater. • Make sure that the rating level is correct. Playback does not start immediately when the Play/Pause button is pressed. • Are you using a deformed disc or a disc with scratches on the surface? • Wipe the disc clean. Sound is not produced. • No sound is heard during fast playback, slow playback, and step motion playback. • Are the speakers connected properly? Is the speaker setup correctly customized? • Is the disc severely damaged? Sound can be heard only from a few speakers and not all six. • When listening to a CD or radio, sound is output to the front speakers (L/R) only. Select "PRO LOGIC II" by pressing (Dolby Pro Logic II) on the remote control to use all six speakers. • Make sure that the DVD disc is 5.1-CH compatible. • If you set C, SL, and SR to NONE in the speaker mode in the audio setup of the setup screen, no sound is heard from the center speaker and the front left and right speakers. Set C, SL, and SR to SMALL. Picture does not appear, sound is not produced, or the disc tray opens 2 to 5 seconds later. • Was the Home Theater suddenly moved from a cold place to a warm one? When condensation forms inside the player, remove the disc and let the player stand for 1 or 2 hours with the power on. (You can use the player again after condensation disappears.) Dolby Digital 5.1 CH • Is there "Dolby Digital 5.1 CH" mark on the disc? Dolby Digital Surround Sound is not pro5.1 CH Surround Sound is produced only if the disc is recorded with 5.1 channel sound. duced. • Is the audio language correctly set to DOLBY DIGITAL 5.1-CH in the information display? • Disc is rotating but no pic• Is the TV power on? ture is produced. • Are the video cables connected properly? • Picture quality is poor and • Is the disc dirty or damaged? picture is shaking. • A poorly manufactured disc may not be playable. The remote control does not work. • Is the remote control being operated within its operation range angle and distance? • Are the batteries exhausted? • Have you selected the mode(TV/DVD) functions of the remote control (TV or DVD) correctly? Audio language and subtitles do not work. • Audio language and subtitles will not work for DVDs not containing them. And depending on the disc, they may work differently. Menu screen does not appear even when the menu function is selected. • A...