Votos - 3, Puntuación media: 3.3 ( )

Fabricar: Makita Tamaño del archivo: 1.31 mb Nombre del archivo: Idioma del manual:

Use a smooth, flat motor has stopped by pushing the magnet file to keep the magnet clean and free of button. The indicator light will turn off and the nicks. Clean the surface before attaching base will automatically de-mag. the drill stand to the material. Electronic Switching Rack and Pinion The drill motor may be switched from forward These units have a 10:1 feed ratio: i.e. for ev to reverse without first having to bring the ery pound applied to the handle, you create motor to a full stop. Ideal for tapping. ten pounds on the drill point, thereby eliminating operator fatigue. Even large bits only Soft-Start require a small amount of pressure on the Soft-start is incorporated into the system to handle. Example: 20 Pounds on the handle help increase drill motor life and decrease creates 200 Pounds on the drill point. stress on the overall system. This feature increases the drill motor speed up from to the maximum speed set by the dial than one (1) second. Feedback/Speed Control The electronic speed control the user to obtain repeatable at a given speed the constant change speed controls. 8 WARNING To reduce the risk of injury, always use a safety chain when drillingoverhead or on a vertical surface. Safety Chain C-clamp Fig. 5 A safety chain is standard equipment with every unit. Should a power loss occur, the mounting could come loose. When mounting the tool to a vertical surface, the safety chain must be used to secure the tool to the surface. 1. To mount the tool to a vertical surface, place the magnetic drill press on the prepared surface. Push the magnet button on to activate the magnet. 2. Route the safety chain through the lower carrying handle and wrap it tightly around a solid, rigid structure as shown (Fig. 5). 3. Eliminate any slack in the chain. Hook the safety chain together using the snaphook provided. 4. Secure the safety chain with a c-clamp or similar device. This will hold the chain in place and prevent the tool from sliding down the vertical surface. WARNING To reduce the risk of injury, wear safety goggles or glasses with sideshields. Unplug the tool beforechanging accessories or makingadjustments. Control Panel Fig. 6 A B CD, E A - Drill Rotation Speed - Fast/Slow Adjusting the dial changes the drill rotation speed electronically. The higher numbers on the dial produce faster rotation. B - Forward Drill Button C - Reverse Drill Button The drill may be set to two positions: forward and reverse. 1. For forward (clockwise) rotation, push the green forward button. Check the direction of rotation before use. 2. For reverse (counterclockwise) rotation, push the yellow reverse button. Check direction of rotation before use. D - Magnet Button - On/Off The magnet button must be activated before the drill will run. 1. To turn the magnet on, push the “Magnet” button. The red indicator light will turn on. 2. To turn the magnet off, push the “Magnet” button. The red indicator light will turn off...

Descargar ahora

Introduzca dos números de la imagen: