Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
It is a very good choice for light duty work and occasional building or remodeling projects. Not only will it DRILL holes in practically any material, but with optional accessories it can SAND, POLISH, BUFF, DRIVE SCREWS, GRIND, DRIVE HOLE SAWS, MIX PAINT, PUMP WATER and REMOVE rust and old paint. For personal safety and for proper operation of the Drill, please take the time to carefully read all of the safety rules and instructions in this booklet. Don't forget to send in the guarantee registration card. THANK YOU for buying BLACK & DECKER! SAFETY SEAL 133 power tool institute Cat. No. Capacity Steel Hardwood Volts AC Amps HP Switch R.P.M. 7010 W' У2" 120 2.3 Уб Single Speed 2250 7011 lÁ" Уг" 120 2.3 Уб 2-Speed 1600 or 2250 7020 V*" У2” 120 2.3 Уб Variable Speed 0 to 2250 7110 %" 3Á” 120 2.5 Ye Single Speed 1000 7120 %" з/4" 120 2.5 Уб Variable Speed Oto 1000 #7020 & #7120 DRILLS Va" & %" DRILLS IMPORTANT INFORMATION Safety Rules for Power Tools The use of the Safety Seal of the Power Tool Institute assures you that this tool is produced and tested in accordance with applicable national safety standards. Operational safety, however, depends to a great extent upon the user of the tool. Please pay close attention to the following rules. * 1. KNOW YOUR POWER TOOL — Read owner's manual carefully. Learn its applications and limitations as well as the specific potential hazards peculiar to this tool. 2. GROUND ALL TOOLS - UNLESS DOUBLE-INSULATED. If tool is equipped with three-prong plug, it should be plugged into a three-hole electrical receptacle. If adapter is used to accommodate two-prong receptacle, the adapter wire must be attached to a known ground. Never remove third prong. 3. KEEP GUARDS IN PLACE and in working order. 4. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents. 5. AVOID DANGEROUS ENVIRONMENT. Don’t use power tool in damp or wet locations. And keep work area well lit. 6. KEEP CHILDREN AWAY. All visitors should be kept safe distance from work area. 7. STORE IDLE TOOLS. When not in use, tools should be stored in dry, high or locked-up place — out of reach of children. 8. DON'T FORCE TOOL. It will do the job better and safer at the rate for which it was designed. 9. USE RIGHT TOOL. Don't force small tool or attachment to do the job of a heavy duty tool. 10. WEAR PROPER APPAREL. No loose clothing or jewelry to get caught in moving parts. Rubber gloves and footwear are recommended when working outdoors. 11. USE SAFETY GLASSES with most tools. Also face or dust mask if cutting operation is dusty. 12. DON'T ABUSE CORD. Never carry tool by cord or yank it to disconnect from receptacle. Keep cord from heat, oil and sharp edges. 13. SECURE WORK. Use clamps or a vise to hold work. It’s safer than using your hand and it frees both hands to opera...
Otros modelos de este manual:Taladros y shuropopverty - 7010 (2.4 mb)
Taladros y shuropopverty - 7011 (2.4 mb)
Taladros y shuropopverty - 7020 (2.4 mb)
Taladros y shuropopverty - 7110 (2.4 mb)