Votos - 5, Puntuación media: 3.6
(
)
)
|
Resumen del manual
It contains important information for safe use, installation and care of the appliance. ! Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. Fitting the appliance Use a suitable kitchen unit to ensure that the appliance functions properly. • The panels adjacent to the oven must be made from heat-resistant material. • Cabinets with a veneer exterior must be assembled with a glue that can withstand temperatures of up to 100°C. • To install the oven under the counter (see diagram) or in a kitchen unit, the cabinet must have the following dimensions: ! The appliance must not come into contact with electrical parts once it has been installed. The figures indicated on the data plate have been calculated for this type of installation. Ventilation To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). Centring and fastening Position the 4 tabs on the side of the oven according to the 4 holes on the outer frame. Adjust the tabs according to the thickness of the cabinet side panel, 20 mm thick: take off the removable part of the tab (see diagram). 18 mm thick: use the first groove, which has already been set in the factory (see diagram). 16 mm thick: use the second groove (see diagram). Secure the appliance to the cabinet by opening the oven door and fastening 4 screws into the 4 holes of the outer frame. 4-----i---------4----V-----V----V--- ! All parts ensuring the safe operation of the appliance must not be removable without the aid of a tool. as shown below: 2 Electrical connections ! Ovens equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate located on the appliance (see below). Fitting the power supply cable 1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram). 2. Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure). 3. Remove the wire contact screws L-N- -i- , then fasten the wires under the screw heads, respecting the colour code: Blue (N), Brown (L) and Yellow-Green Verde (i). Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate (see adjacent box). The appliance must be directly connected t...
Otros modelos de este manual:Hornos - FB G /HA (4.75 mb)
Hornos - FB G IX /HA (4.75 mb)
Hornos - FH G /HA (4.75 mb)
Hornos - FH G IX /HA (4.75 mb)