Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
Caution! Surface damage due to incorrect cleaning: Do not use any ¦ harsh or abrasive cleaning agents ¦ cleaning agents that contain alcohol ¦ abrasive cleaning aids such as steel wool or scourers. Observe the specifications in the tables. Note: Highly recommended cleaning and care products can be purchased through our after-sales service. Observe the manufacturer's instructions. Cleaning the appliance exterior Appliance part/ sur- Cleaning agent/ aid face Stainless steel sur- Apply washing- up liquid with a soft, faces damp cloth or chamois; dry with a soft cloth. Use cleaners for matte stainless steel finishes if very dirty. Painted surfaces/ Apply washing- up liquid with a soft, glass surfaces damp cloth or chamois; dry with a soft cloth. Door panels Apply glass cleaner or detergent with a soft, damp cloth or chamois leather; dry with a soft cloth. The inner door panel on the appliance door has a coating which can have the effect of a light- coloured film. Cleaning the cooking compartment Caution! Risk of damaging the surface. Do not clean the appliance while still warm, even if using oven cleaners specially intended for this purpose. Notes ¦ Due to its technical properties, the enamel may exhibit colour variations. However, this has no effect on the function. ¦ The edges of thin trays may be rough. However, anticorrosion protection is still guaranteed. Appliance part Cleaning agent/ aid Enamel surfaces Apply washing- up liquid or vinegar solution with a soft, damp cloth or chamois; dry with a soft cloth. Loosen baked- on food residues with a damp cloth and detergent. Leave the cooking compartment open to dry after cleaning. We recommend using oven cleaner if the oven is very dirty. If using oven cleaner, follow the manufacturer's instructions. Door seal Hot soapy water Hook- in rack/ tel- Hot soapy water escopic shelf Accessories Soak in hot soapy water. Clean with a brush and sponge or wash in the dishwasher. Keeping the appliance clean Clean the cooking compartment after each use, as dirt will bake on the next time it is heated up, and this can only be removed with difficulty. Always remove flecks of limescale, grease, starch and albumin (e. g. egg white) immediately. Where possible use the 3 Hot air operating mode. This operating mode creates less dirt. Removing and fitting the appliance door You can remove the appliance door to clean it more thoroughly. : Risk of injury! The hinges of the appliance door may snap shut with great force. Always open the hinge locking lever fully when removing the appliance door and close it fully after refitting. Do not reach into the hinge. : Risk of injury! If the appliance door has only been unhinged on one side, do not reach into the hinge. The hinge can snap back with great force. Call the aftersales service. Removing the appliance door 1. Open the appliance door fully. 2. Open the locking levers on the left and right- hand side fully. 4. With both hands, grip the door on the left and right- hand side, close the door a little more and pull it out (figure B) . Fitting the appliance door 1. Insert the hinges in the left and right-hand holders (figure C) . The notch on both hinges must engage. 2. Open the appliance door fully. 3. Close the locking levers on the left and right-hand side fully (figure D). The appliance door is secured and can no longer be removed. 4. Close the appliance door. Cleaning the door panels To assist with cleaning, the inner door panel can be removed from the appliance door. : Risk of injury! The components inside the appliance door may have sharp edges. Take care not to cut yourself. Wear protective gloves. : Risk of injury! The appliance must not be used again until the door panels and appliance door have been correctly fitted. Removing the door panel Note: Before removing, make a note of which way round the door panel is fitted, so that it is not refitted the wrong way round. 1. Unhook the appliance door and lay it on a soft, clean surface with the front side facing downwards (see section: Removing and fitting the appliance door) . 2. Pull off the cover at the top of the appliance door. Press in the tabs on the left and right using your fingers ( fig. A) . 3. Lift the door panel and pull it out (figure B). The hinges are secured and cannot snap closed. 3. Close the appliance door until resistance becomes noticeable ( figure A) . . . Cleaning Clean the door panel with glass cleaner and a soft cloth. : Risk of injury! Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, or sharp or abrasive cleaning aids or detergents. Fitting the door panel 1. Insert the door panel at an angle towards the back into both brackets as far as it will go. The smooth surface must face outwards. 2. Put the cover back in place and press on it until it clicks in place. 3. Refit the appliance door. Cleaning the hook-in racks You can remove the hook-in racks for easier cleaning. : Risk of burning due to hot components in the co...