Votos - 5, Puntuación media: 4.6
(
)
)
|
Resumen del manual
6. Disc Do not use irregularly shaped discs such as heart or star-shaped discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping the disc from the center out with a cleaning cloth. Remove the disc from the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the software producers designed, some playback features may not be available. Also refer to the instructions supplied with the discs. 7. Regional Coding Both the DVD player and disc are coded by region. These regional codes must match in order for the disc to play. If the codes don’t match, the disc won’t play. This unit’s code is region 1. DVD’s with other regional codes cannot be played in this unit. C. Contents 1. 1 x 8 ” LCD Monitor and DVD Player 2. 1 x AC to DC Adapter 3. 1 x Remote Control w/Battery (CR2025) 4. 1 x Instruction Manual 5. 1 x Audio/Video Cable 6. 1 x DC Power Adapter 7. 1 x Carry Bag With Straps 8. 2 x Foldable Headphones 4 D. Powering and installation 1. Powering the system indoors (Refer to Figure 1) Plug one end of the AC to DC adapter into the DC 9-12V jack on the right side of the main unit, then plug the other end into the 100240V AC power receptacle. Figure 1 2. Powering the system in a car (Refer to Figure 1) Plug one end of the DC power adapter into the DC jack on the unit, then plug the other end into the vehicle‘s DC power socket. 3. Built-in Battery Slide the Power On/Off Switch to Off position. Plug one end of the AC to DC adapter into the DC jack on the side of the player, then plug the other end into the 100~240V AC power outlet. The charge light will flash for about 3 seconds, then it turns to red. Once fully charged, the LED indicator will be green. Then remove the AC to DC adapter wall plug. NOTE: Your new battery must be charged a minimum of 8 hours before the first usage. Each full recharge takes approximately five hours and one full charge can provide power to the player for approximately 2 hours. 5 E. Vehicle Installation Installing the DVD Player onto the seat back in a car (Refer to Figure 2) Carry Bag Opened Headrest Strap Seat Back Strap Elastic Straps Carry Bag Closed Vehicle Seat Back Vehicle Headrest Figure 2 1). Unfold the carry bag, and place the DVD player on the bag beneath the elastic straps. Ensure that the unit’s corners are secured by the elastic straps. 2). Secure the upper portion of the carry bag to headrest support bars using the headrest strap. Adjust the headrest strap until the bag is firmly secured. 3). Secure the lower portion of the carry bag to the vehicle seat back using the seat back strap. Adjust the seat back strap until the bag is firmly secured. 6 7 F. Controls, Indicators, and Connectors 1. Unit View (Refer to Figure 3) Figure 3 1) LCD Panel Shut Off Switch 2) Wide Button 3) Stop Button 4) Previous Button 5) Next Button 6) Play Button 7) Menu Button 8) Up Button 9) Right Button 10) OK Button 11) Down Button 12) Left Button 13) Open Door Switch 14) IR Sensor 15) Power LED 16) Power on/off Switch 17) Volume Up/Down Control 18) Headphone 1* 19) Headphone 2 20) Charge Indicater 21) AV Out Jack 22) DC 9V Input Jack *Using headphone jack 1 will disable the internal speakers 2. Remote Control View (Refer to Figure 4) 1) Setup Button 2) Up Button 3) Previous Button 4) Enter Button 5) Reverse Scan /Left Button 6) Down Button 7) Numeric Keypad 8) Display Button 9) Zoom Button 10) Subtitle Button 11) Next Button 12) A-B Repeat Button 13) Forward Scan /Right Button 14) 1/All Repeat Button 15) Stop Button 16) Menu Button 17) Audio Button 18) Angle Button 19) Play/Pause Button Figure 4 G. Loading and Playing a Disc a. After connecting power to the unit, apply power to the DVD player with the power switch. The power indicator will light. b. Open the disc tray by pressing OPEN button and place a disc into the tray with the label side facing up. c. Close the tray by pressing the “PRESS” button. The unit will load the disc and start playing. d. Rotate the VOLUME control to adjust the DVD player’s volume. e. To stop playing a disc, press STOP. f. To turn off the DVD player, slide the POWER ON/OFF switch to OFF. 8 H. SETUP Press ‘SETUP’ to display the Main screen of the SETUP Menu on the screen. Press ‘SETUP’ again to exit the SETUP Menu. 1) Press SETUP, the ‘GENERAL SETUP PAGE’ will display on screen. General Video Password Preferen Exit Angle Mark Off Main Setup Menu Screen a).Select ‘TV DISPLAY’ using the DOWN button, and then press ‘ENTER’ to enter the submenu. Select the TV display mode on the screen using UP/DOWN, and press ‘ENTER’ to confirm the setting. Press LEFT to return. * NORMAL/PS: When the player is connected to a normal TV, and a wide picture is...