Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
1 Remove the rear support from the unit. 2 Remove the control panel and trim ring from the unit. A 3 Insert the lever A into the hole on one side of the unit. Perform the same operation on the other side and pull the unit out from the mounting sleeve. CAR CD/MP3/WMA Receiver Connection Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. Wired remote input(Black): Hard-wired control adapter can be connected. (Optional/Not supplied) To Audio in (OPTIONAL) Amplifier (OPTIONAL) BATTERY B 1 B 2 B 3 B 4 B 5 B 6 B 7 B 8 1 2 3 BA4 1 2 3 5 6 7 8 4 5 6 7 8 A 8 Power Antenna(Blue) A 7 Dimmer(Pink) A 2 To Ignition(Red) A 1 To Battery(+)(Yellow) A 5 Ground(-)(Black) Power Antenna Control Relay Ignition Switch Dimmer Switch A 4 Phone Mute(Orange) A 3 Remote On(Blue/White) Front Left Front Right Rear Left (Sub-woofer Left) Rear Right (Sub-woofer Right) *Sub-woofer is optional. To Audio out (OPTIONAL) Amplifier (Optional) A 6 Not connected B 1 Violet / Black Stripe : Rear Right – B 2 Violet : Rear Right + B 3 Gray / Black Stripe : Front Right – B 4 Gray : Front Right + B 5 Green/ Black Stripe : Rear Left – B 6 Green : Rear Left + B 7 White/Black Stripe : Front Left – B 8 White : Front Left + CAR CD/MP3/WMA Receiver Basic Operation ON PLAYER ON REMOTE 1. Turn the unit on. 2. Select a source. 3. Adjust the volume. 4. Turn the unit off. Any key SRC Rotate the volume knob Press and hold OFF - SRC VOLUME Press and hold OFF Basic Operation ON PLAYER ON REMOTE 1. Turn the unit on. 2. Select a source. 3. Adjust the volume. 4. Turn the unit off. Any key SRC Rotate the volume knob Press and hold OFF - SRC VOLUME Press and hold OFF Basic operation - more you can do Mute 1. Press MUTE to cut the sound. 2. To cancel it, press again. Using EQ(Equalizer) EQ is to increase or decrease the signal strength of audio frequencies. The func tion helps you to enjoy sound more plentifully. Press EQ/ • XDSS+ on the unit repeatedly. The indicator lights up in the following order. POP t CLASSIC t ROCK t JAZZ t VOCAL t SALSA t SAMBA t REGGAE t RUSSY t USER1 t USER2 t Off(not displayed) Note • When XDSS+ is set to “Off”, you can adjust the EQ settings. • You can adjust sound level to your preference. Once you select a USER mode and press [SOUND], then adjust the sound level(BASS(bass), MID(middle), TRB(treble)), it will be automatically stored for the currently selected USER mode. Refer to the “For sound setting” for USER 1/2 mode. Using XDSS+ (Extreme Dynamic Sound System) It improves the treble and bass sound. 1. Press and hold EQ/ • XDSS+ on the unit. 2. To cancel it, press and hold it again. Checking the clock 1. Press DISP once to check the clock. 2. Press it again to remove it. Turning off the display light 1. Press and hold DISP. 2. Press and hold it again to turn it on. Note Under the light-off condition, press any keys, the light is turned on and then off automatically if you don’t press it within a few seconds. Resetting the unit It resets the unit when it does not operate properly. 1. Press [ ] and pull out the front panel. (Refer to page 6 for detaching the control panel.) 2. Prick the RESET hold with sharp object. Adjusting general settings You can adjust sound, light and other settings by using the MENU button. On the Unit 1. Press MENU. 2. Rotate the volume knob to select [SOUND], [LIGHT], or [OTHER] and press it. 3. Rotate the volume knob to select the item and press it. 4. Rotate the volume knob clockwise or counterclockwise to adjust the level. 5. Press the volume knob to confirm the setting. If you want to return to the previous step, press . On the Remote Control 1. Press and hold FUNC/ • MENU 2. Press v or V to select [SOUND], [LIGHT], or [OTHER] and press ENTER. 3. Press v or V to select the mode and press ENTER. 4. Press v or V to adjust the level. 5. Press ENTER to confirm the setting. If you want to return to the previous step, press . For Sound setting You can adjust sound quality by adjusting the level of BAL(left/right speaker), FAD(front/rear speaker) and S--W(Sub-woofer:optional). CAR CD/MP3/WMA Receiver For Light setting You can adjust the light effects by adjusting LED, DIM, or DIM L. • LED COL1/ COL2/ AUTO: You can change the LED window color. • DIM(Dimmer) OFF / ON / AUTO : You can change the brightness of the display window during the power-on status. When you set DIMMER to AUTO, the dimmer operates according to the car dimmer setting. • DIM L (Dimmer Level): When you set DIM to ON/AUTO, you can adjust the dimmer level. (-2,-1,0,+1,+2) For Other setting • AUX (Auxiliary) ON / OFF It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. • BEEP 2ND / ALL BEEP 2ND : The beep is generated when a key is long pressed. (1 sec) BEEP ALL : The beep is generated when any key is pressed. • A-EQ(Auto EQ) ON/OFF AUTO EQ operates only in the music file supported with...